Calibration of Network Analyzers

1. Select the calibration button

2. Press the reset button to reset the instrument.

3. Set the frequency band to be tested and the start and end frequencies

4. Select Format

5. Select the Smith chart, the interface is as follows:

6. Press Cal to enter the calibration interface, which is as follows:

7. Select Calibrate>1-Port Cal to enter the following interface

8. Then connect the open circuit, short circuit, and load in the calibration parts to the No. 1 port of the instrument in order, and click the open button after connecting the open circuit calibration part, replace the short circuit calibration part, click the short button, and finally replace the load calibration part, click the Load button, and then click the Done button. The calibration is completed.