Maintenance knowledge of chlorine dioxide detector

      The chlorine dioxide detector is an instrument used to detect whether chlorine dioxide exists in a certain environment. For the chlorine dioxide in the environment being tested. Maintenance is an important task to improve the stability, accuracy and life of the detection instrument. It is also an important task to effectively prevent failures. For the maintenance of the chlorine dioxide detector, we need to do the following:
1. Keep the detection instrument dry and strictly prohibit contact with water droplets. And avoid direct contact with corrosive liquids.

2. It is strictly forbidden to use the gas detector in a high-temperature environment. Using the instrument at high temperature may permanently damage the sensor. Please refer to the temperature range of the instrument. 3.

For detection instruments that have not been dust-proofed, do not use the instrument in an environment with too high dust density.

4. There is a warm-up time when the gas detector is turned on. For the 120-second countdown jump, it is not a problem with the instrument. Please wait patiently. Do not knock the instrument.

5. Check the air inlet of the detector frequently for leakage and blockage to keep the air inlet unobstructed.

6. It is strictly forbidden to use the chlorine dioxide detector to detect an environment with unknown concentration to avoid permanent damage to the sensor.

7. If the testing instrument is accidentally flooded, please do not open the instrument, disassemble the casing, promptly remove the water droplets on the instrument, and place it in a ventilated place for 48 hours, and return it to the manufacturer for re-inspection and recalibration.

8. For chlorine dioxide detectors that have not been dust-proofed, they need to be used in dusty places. Please use emery cloth or paper towels to place them at the air inlet. (This method cannot be used for a long time)

9. If the gas detector has any abnormality, please communicate with the manufacturer's technical staff in time. Do not disassemble or repair the detector privately. Because the detector is calibrated with standard gas before leaving the factory