Insertion type electromagnetic flowmeter sensor has the following features

There are no moving parts in the sensor, the structure is simple and the operation is reliable.
The plug-in structure can be easily installed and disassembled without stopping water under low pressure or pressure. Therefore, it is very suitable for fluid measurement in existing pipelines and is convenient for maintenance and repair of instruments.
The measurement accuracy is not affected by changes in physical parameters such as temperature, pressure, density, viscosity, conductivity (as long as the conductivity is greater than 5µs/cm) of the measured medium.
The sensor has almost no pressure loss and extremely low energy loss.
The manufacturing cost and installation cost are lower than those of general electromagnetic flowmeters. It is particularly suitable for flow measurement in large and medium diameter pipelines.
It adopts advanced low-frequency square wave excitation. It has stable zero point, strong anti-interference ability and reliable operation.
The flow measurement range is large. The full-scale flow velocity in the measured pipeline can be set arbitrarily from 1m/s to 10m/s, and the output signal is linearly related to the flow rate.
The flowmeter not only has 0~10mA DC or 4~20mA DC standard current output, but also 1~5kHz frequency output