As shown below, this is the test schematic diagram of CFA op amp, THS3001. Is the 50 ohm at the input port an actual resistor or the characteristic impedance of the interface?
Other questions:
1. For
Memory Technology's recent expert position requirements:SSD unit test expert (system test technology/FA expert, responsible for building unit test architecture) (Suzhou/Dongguan)NAND media test expert
Hello everyone, I'm here to ask for help again. The picture shows a designed serial port 3.3V and 5V compatible solution. The problem I'm encountering now is that the two transistors will burn out. Th
[i=s]This post was last edited by sipower on 2020-5-28 23:05[/i]The previous posts shared my preparations and system block diagrams. This time I will share something that has little to do with sensors
1. There are two Siemens S7-1200PLCs and a DCS system on site. The DCS system acts as a Modbus TCP master station and provides Modbus TCP protocol type data, while the two S7-300 PLCs on site use the