[i=s]This post was last edited by Shenzhen Xiaohua on 2020-12-13 12:15[/i]I downloaded a source code from the Internet. I don't know what software it was developed with. As shown in the figure below,
My motor has two operating voltages, 12V and 7V. The working current is 800mA at 7V. When starting, it needs to run at 12V for a while, and then switch to 7V. I want to use MOS tube to control the ope
# 3D Printer Project - STM32F750 Startup Program (Part 2) ## Overview Since the chip STM32F750N8H6 used in STM32F7508-DK belongs to the STMicroelectronics Arm Cortex-M7 core, the built-in FLASH is onl
The device is powered by 12V, plus a 12V lithium battery backup power supply, the charging voltage is 12.6V, I thought about integrating a charging circuit into it, 12V can be charged directly, but it
[i=s]This post was last edited by annysky2012 on 2021-2-23 17:18[/i]Based on my strong interest in STM32 motor control, I applied for the NUCLEO-F746ZG development board. The ultimate goal of this stu