I have recently come into contact with some domestic chip manufacturers. Many of them have to sign NDA (non-disclosure agreement) to buy development boards and obtain information. Some of them need to
It is very convenient to use Arduion to program STM32. Currently, it can support many ST official boards, as shown in the figure below. However, when downloading, there is basically no speed. I think
[i=s]This post was last edited by Hot Ximixiu on 2020-9-12 19:56[/i]4,0,0; // 5UCA0CTL1 |= UCSWRST; // **Put state machine in reset**6 UCA0CTL1 |= UCSSEL_2; // CLK = SMCLK7 UCA0BR0 = 26; // 24MHz/5760
[align=center][/align] [align=center][align=left]On September 12, at the popular STMicroelectronics conference held in Beijing, engineers from Airlabi gave a wonderful presentation to engineers at the
Abstract: To improve the range resolution, the bandwidth of the transmitted signal is usually increased, which leads to a high sampling rate and A/D conversion rate of the system, a sharp increase in