Connect the wires as above. Then, connect the jumper cap and set the serial port parameters.The baud rate is 57600. Thank you Qin Heng and eeworld.This content is originally created by EEWORLD forum u
[i=s]This post was last edited by dj狂人 on 2021-8-24 10:30[/i]Hey guys, I have a question. As shown in the figure below, the program storage space of this single chip is in OTP format. I have never und
Communication Electronic Circuits : https://training.eeworld.com.cn/course/5031This course mainly studies the working principle and composition of each unit of the transmitting and receiving equipment
Netizens:Hello! Thank you for your continued support! I wish you all a happy National Day!From 13:00 on September 30 to 10:00 on October 8, the community will make the following adjustments:1. Forum p