In PCB design, after setting the board outline, call the parts (footprint) into the workspace. Then reposition the parts to the correct location and wire them when finished.
Component placement is the
[i=s]This post was last edited by TL-LED on 2022-6-2 14:27[/i]1. Project Background
When testing products, it is often necessary to view the data of the specified ID on the CAN communication. Sometime
The schematic diagram is designed using TI's WEBENCH. When outputting 48V/1A, the temperature of the MOS tube reaches 100°C. Is this temperature too high?
attach://600758.pdf
Temperature detection is a necessary monitoring when we are at home, in and out of the community or workplace, and when traveling. Infrared thermometers help reduce contact transmission through non-co