pdf

Discuss the changes in hardware and software requirements needed to change the design from MC68HC705J2 to MC68HC705JJ7

  • 2013-09-18
  • 200.7KB
  • Points it Requires : 1

This application note describes the changes needed in both hardwareand software to migrate a design from the MC68HC705J2 (J2) to theMC68HC705JJ7 (JJ7). Not only is the JJ7 less expensive than the J2,but migrating to the JJ7 also allows the designer to utilize some of itsfeatures not found on the J2.The JJ7’s additional features are:• 6160 bytes of user EPROM; J2 has 2064 bytes• 224 bytes of low-power user RAM; J2 has 112 bytes• 64 bits of personality EPROM, serial port accessible• 16-bit programmable timer with input capture and output compare• Simple serial input/output port (SIOP) with interrupt capability• Two voltage comparators, one of which can be combined with the16-bit programmable timer to create a 4-channel, single-slope A/D(analog-to-digital) converter• Output of voltage comparator can drive port pin PB4 directly undersoftware control• High-source/sink current capability on six I/O (input/output) pins

unfold

You Might Like

Uploader
rubyonrails
 

Recommended ContentMore

Popular Components

Just Take a LookMore

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号
×