This is the source code for the ls program in the gnu program.-Embedded Development-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

Problem of negative voltage shutting down power tube
As shown in the figure, the half-bridge inverter topology composed of two power tubes has a turn-on voltage of +20V as shown in the figure, and a turn-off voltage of -8V. These two power supplies are
Micropython spectrometer
From: https://myspectral.com/project/lumini-t/Lumini T Spectrometric Camera Now available from stock!USB Spectrometric camera. Ultrafast. Rugged. Multiplatform software, which will remain always free.
Various bus transmission rates
1. USB bus USB1.1: -------Low speed mode: 1.5Mbps -------Full speed mode: 12Mbps USB2.0: backward compatible. Added high-speed mode, with a maximum rate of 480Mbps. -------High speed mode: 25~480Mbps
Free application: New version of Zhongke Bluexun AB32VG1 RISC-V development board
Development board for this evaluation: Zhongke Bluexun AB32VG1 development boardProvider: RT-ThreadQuantity: 5 piecesBluexun Jiaolong AB32VG1 is the independent RISC-V core 32-bit MCU chip released by
【GD32L233C-START Review】-V. GD32 transplants atomic serial port debugging components to implement serial port function debugging
When I used stm32 before, I was deeply impressed by the serial port debugging component of Atom, so I transplanted the component to test the serial port function debugging function.The Atom component
555 classic circuit diagram: 555 simple delay circuit diagram
[Sipeed LicheeRV 86 Panel Review] 7. fbviewer and ts_test command test
HyperLynx High-Speed Circuit Design and Simulation (III) Termination Resistance Experiment
TUSB9261 -- USB3.0 to SATA interface bridge chip programming guide
How about the Qinheng RISC-V core CH32V103 microcontroller?

Trending Downloads

This is the source code for the ls program in the gnu program.

Document Introduction