-
2. [Learning LPC1768 library functions] Keystroke experiment
The key experiment is essentially to operate the GPIO pins of Lpc1768, but unlike the LED experiment, the key experiment is to read the GPIO pin value. As can be seen from the figure below, when the k
-
How to change UDP point-to-point communication to UDP broadcast communication
I used the Zhengdian Atom board to test the network port program, and the UDP point-to-point communication was successful. I want to change to broadcast mode and set the target IP address to 255.255.2
-
Design of a USB reader based on embedded system
[size=4][color=#222222][font="] With the rapid development of USB technology and flash memory technology, the speed and capacity of mobile storage devices are changing with each passing day. However,
-
Understand the development principle of WiFi endoscope HD wireless camera in wireless communication module function in one article
When it comes to wifi video transmission, do you first think of the need for a core module with video compression SOC, a huge system, a complex remote server, etc., and the excessive budget cost makes
-
Analysis of common problems in TWS headset design
Some common problems that are easy to occur during the design process:The two CC1 and CC2 pins of the TYPE-C USB of the charging case cannot be short-circuited together, and each must be connected to
- AD18, keepout options are all grayed out, and I can't use keep out wiring. What should I do?
- [Raspberry Pi Pico Review] Simple test of power on with uf2 file
- [NXP Rapid IoT Review] + NXP Rapid IoT interface design process
- Basic Considerations for Sensors in Powertrain Systems
- How do I calculate the capacity of the supercapacitor I need?