First upload the source packageThe development board uses the DAP tester, so use DAP-RTT. There is also Jlik_RTT, which you can use by yourself.
DAP——RTT software (in the source code package, just unz
As shown in the following figure, the left side is the read timing diagram of STM32 FSMC mode A, and the right side is the read timing diagram of SRAM. From the figure, STM32 can only set the tRC time
[i=s]This post was last edited by cqcqwind on 2022-5-6 12:17[/i]After the dynamic loading platform of 2601 was completed, HELLO WORLD, GPIO, U8G2, and DHT11 were tested, and all met expectations. Out