AVR ATMEGA128 and FPGA EP1C6Q240C6 development board-Embedded Development-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

How to improve the load capacity of power chip
I built a bandgap circuit at school according to the structure of a foreign chip, but the simulation found that the load capacity is not good; and I have to add capacitors to sacrifice bandwidth to co
ESP32 development board that looks like Raspberry Pi Zero
The ATMegaZero ESP32-S2 is an ESP32 development board that looks just like the Raspberry Pi Zero, which means the shape and 40-pin GPIO interface are the same as the Pi Zero, and the same accessories
Where is the best place to place the ESD on the PCB?
[i=s]This post was last edited by we36147 on 2022-9-26 01:25[/i]Where is the best place to place the ESD on the PCB?
High pass filter, low pass filter, notch filter
High pass filter, low pass filter, notch filter High-pass filter cutoff frequency:f H =1/2π × 510 ×10^3×10 ×10^-6= 0.03 Hz Low-pass filter cutoff frequency:f L =1/2π× 1.5×10^3×1×10^-6= 106 Hz Notch ce
Rectification and filter capacitor selection
I would like to ask, how to choose the capacitance of the filter capacitor after the diode full-wave rectifier? The power supply voltage is 4000V, the current is 30A, and the frequency is 400Hz. I hav
The problem of fast charging damaging the battery
Configuration and use of TMS320F28379D SCID SCIB
[Domestic RISC-V Linux Board Fang·Starlight VisionFive Trial Report] Create User Data Insertion
What does the message NETS CONTAINING FLOATING INPUT PINS mean in AD?
The sorrow of liberal arts students: the recruitment process of HR who does not understand technology

Trending Downloads

AVR ATMEGA128 and FPGA EP1C6Q240C6 development board

Document Introduction