Currently, a servo motor is used to drive the device to slide, and it will stop at a fixed position. This is currently achieved by photoelectric switches, but one problem with photoelectric switches i
[color=#008000][backcolor=rgb(255, 255, 255)][font=Tahoma,]Excuse me, how to convert the linear velocity and angular velocity of the six-axis data collected into angle and acceleration? Can LSM6DSM su
Hello everyone, I work in RF, I don't know much about digital aspects, and I use few chips. Recently I am working on a project that requires using logic circuits to control the on and off of the RF sw
After a long wait, the package finally arrived. Now I will make an unpacking report.First of all, the packaging box is very large.After unpacking, the upper and lower layers inside are protected by th
Recently, when I used CCS to connect XDS100V3 to debug CC1310, I found that I could not connect to the target board.
The following error is reported during Verify:
[Start]
Execute the command:
%ccs_ba