1. There are signals in and out, and there may be a clk. When in changes from low level to high level, out should output high level immediately. No matter how in pin changes, out should not change. Ho
Nexperia Award-winning Live Broadcast: Introduction and Application of Automotive Power MOSFET and GaN Devices in Electric VehiclesClick here to enter the live broadcastLive broadcast time: October 18
Question: After purchasing the shenhuo603 board from Taobao, ztool cannot scan the device after downloading itSolution: 1. Correct pin configuration (hal_board_cfg.h)
2. Code segment configuration, op
Have you used TI's ADS1278 for AD acquisition? During the test, I found that if the input signal exceeds the reference voltage, the analog-to-digital converted signal is not a distorted sine wave with