RoHS Compliant in Accordance with EU Directive 2011/65/EU
- Lead-Free Termination Finish
- Exemption 7(c)-I, Electrical and electronic components containing
lead [Pb] in glass
Part Weight:
14 Pin
•
156.50mg
16 Pin
•
178.90mg
Applications
Telecom Infrastructure
Optical Networking
Wireless Networks
Edge Routers
Internet/Network Security
Storage Area Networks
Network Attached Storage
Switches
RAID Controllers
Description
766 Series Resistor Networks are single packaged devices containing an array of homogeneous resistor elements.
CTS network designs provide a smaller circuit footprint, excellent reliability, improved TCR tracking and resistor
tolerance matching; while helping to save placement costs by reducing application component count.
Ordering Information
Model
766
N um ber
of Pi ns
16
Schem a ti c
3
Res i s tor
Code
103
Res i s tor
T ol era nce
G
RoHS
Com pl i a nt
P
Pa cka g i ng
T R7
Code
14
16
Pin Count
14 Pins
16 Pins
Code Resistor Value *
10k ohm
103
* See Addendum for
Standard EIA Values
Code
P
Compliance
RoHS
Packing
Code
Slide Pack
Blank
TR7 Tape & Reel, 7"
TR13 Tape & Reel, 13"
Schematic Type
Code
Bussed Circuit
1
Isolated Circuit
3
5 Dual Terminator Circuit
Ladder Circuit
7
Schematic Types 1 & 3 Schematic Type 5
Tolerance
Code
Code Tolerance
±2% [std]
±2%
G
Blank
±1%
F
±0.5%
D
J
±5%
2
Schematic Type 7
Tolerance
Code
±1 LSB
F
±0.5 LSB
D
[LSB = Least Significant Bit]
Notes:
1. No dashes or spaces to appear in part number.
2. Not supported per PCN ECP-3200029. Use code "G" as standard platform tolerance.
N ot a l l perf orm a nce com bi na ti ons a nd res i s tor va l ues m a y be a va i l a bl e.
Conta ct your l oca l CT S Repres enta ti ve or CT S Cus tom er Servi ce f or a va i l a bi l i ty.
This product is specified for use only in standard commercial applications. Supplier disclaims all express and implied warranties and liability in connection with any use of this
product in any non-commercial applications or in any application that may expose the product to conditions that are outside of the tolerances provided in its specification.
This article comes from the InternetToday, there are more and more possible causes of RF interference, some of which are obvious and easy to track, while others are very subtle and difficult to identi...
As shown in the figure, what is the role and principle of adding a ground via hole near the via hole of the routing? The vias of the PCB board can be classified into the following types according to t...
Generating PWM Waves Using Timers
PWM stands for Pulse Width Modulation. By controlling the duty cycle of high-frequency signals, the eye acts as a low-pass filter to control brightness. By changing t...
I want to debug the LIS25BA sensor. I don't have a level conversion chip, so I want to change the NUCLEO to 1.8V power supply.
For debugging convenience, I first changed the 3.3V LDO of ST-LINK to 1.8...
[i=s]This post was last edited by emmnn on 2022-7-7 11:16[/i] [TOCM] # Preface After running the official DEMO project, you can consider porting the OS. I happened to see the application notes of RT-T...
RF/Wirelessly
京公网安备 11010802033920号
EEWORLD
