Features .......................................................................................................................................................................................1
Ordering Information .....................................................................................................................................................................2
Dimensions and Patterns ― 3.2 x 2.5 mm .................................................................................................................................14
Dimensions and Patterns ― 5.0 x 3.2 mm .................................................................................................................................14
Dimensions and Patterns ― 7.0 x 5.0 mm .................................................................................................................................15
Additional Information .................................................................................................................................................................16
Revision History ..........................................................................................................................................................................17
Rev 1.07
Page 3 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Electrical Characteristics
Table 2. Electrical Characteristics – Common to LVPECL, LVDS and HCSL
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage with standard
output termination shown in the termination diagrams. Typical values are at 25°C and nominal supply voltage.
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
220.000001
-15
-25
-35
-50
Operating Temperature Range
T_use
-20
-40
-40
-40
Supply Voltage
Vdd
2.97
2.70
2.52
2.25
Pull Range
Upper Control Voltage
Lower Control Voltage
Control Voltage Input Impedance
Control Voltage Input Bandwidth
Pull Range Linearity
Frequency Change Polarity
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Start-up Time
OE Enable/Disable Time
PR
VC_U
VC_L
VC_z
V_c
Lin
–
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
Typ.
–
–
–
–
–
–
–
–
–
3.30
3.00
2.80
2.50
Max.
725
+15
+25
+35
+50
+70
+85
+95
+105
Supply Voltage
3.63
3.30
3.08
2.75
V
V
V
V
ppm
Vdd
Vdd
MΩ
kHz
%
–
–
30%
-
55
3.0
3.8
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value.
f = 322.265625 MHz. Measured from the time OE pin reaches
rated VIH and VIL to the time clock pins reach 90% of swing
and high-Z. See
Figure 9
and
Figure 10
Pin 2, OE
Pin 2, OE
Pin 2, OE logic high or logic low
Contact SiTime
for other input bandwidth options
See the APR (Absolute Pull Range)
Table 11.
Contact SiTime
for custom pull range options
Voltage at which maximum frequency deviation is guaranteed
Voltage at which minimum frequency deviation is guaranteed
Unit
MHz
ppm
ppm
ppm
ppm
°C
°C
°C
°C
Extended Industrial
Extended Commercial
Industrial
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated
power supply voltage, load variations, and first year aging
at 25°C, with VIN voltage at Vdd/2.
±15
ppm is only guaranteed for pull range up to
±100
ppm.
Frequency Range
Frequency Stability
Temperature Range
Voltage Control Characteristics
±25, ±50, ±80, ±100, ±150, ±200,
±400, ±800, ±1600, ±3200
90%
–
–
–
–
–
–
10
10
–
Positive Slope
–
–
100
–
–
–
–
10%
–
–
1.0
Input Characteristics
Output Characteristics
Startup and OE Timing
Rev 1.07
Page 4 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
RMS Period Jitter
[4]
RMS Phase Jitter (random)
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
–
0.220
0.270
ps
Min.
–
–
–
–
Vdd-1.15
Vdd-1.9
1.2
–
–
Typ.
–
–
0.15
–
–
–
1.6
225
1.0
Max.
97
63
–
32
Vdd-0.7
Vdd-1.5
2.0
290
1.6
Unit
mA
mA
A
mA
V
V
V
ps
ps
Condition
Excluding Load Termination Current, Vdd = 3.3 V or 2.5 V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 5
See
Figure 5
See
Figure 6
20% to 80%, see
Figure 6
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 156.25 or 322.265625 MHz, IEEE802.3-2005 10 GbE jitter
mask integration bandwidth = 1.875 MHz to 20 MHz,
all Vdd levels
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 322.265625 MHz, IEEE802.3-2005 10 GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, all Vdd levels
I have a question. The circuit board has an external 5V input. The power line is too long, 3 meters. The voltage is too high when it is powered on. Should I use a TVS tube? Or add a filter capacitor? ...
Ask a simple but difficult to answer circuit question: What is the nature of the ground wire GND in the circuit?During the PCB Layout process, engineers will face different GND treatments.Why is this?...
i.MX Linux Development Practical Guide : https://training.eeworld.com.cn/course/5854The first issue - Getting Started with Zero Foundation - 47 episodes The second issue - Kernel Programming - 20 epis...
[backcolor=rgb(222, 240, 251)]I designed an encoder circuit, the circuit is as follows: [/backcolor][backcolor=rgb(222, 240, 251)]Afterwards, when I turned the encoder, there were waveforms on both en...
Software Pipelining
1. C6000 Pipeline
The processing of an instruction is not completed in one step, it is divided into three stages: fetch, decode, and execute. Putting each stage into an independent...
1. Introduction:
The variable air volume (VAV) air conditioning system is an air conditioning system that uses a variable air volume box to adjust the air volume and the fresh air return mixin...[Details]
When using LEDs, attention should be paid to moisture and intrusion prevention standards. The IP (INTERNATIONAL PROTECTION) protection level system was drafted by IEC (INTERNATIONAL ELECTROTECHNICA...[Details]
After writing about Tesla's 4680, I would like to talk about the real cylindrical batteries in China. One company that makes this is Hua Ting Power, which provides solutions to related manufacturers,...[Details]
Regarding KUKA torque monitoring: the variable $TORQMON can be used to monitor the range and alarm.
$TORQMON Torque monitoring channel in program mode, torque monitoring in program mode.
...[Details]
With the development of society and the improvement of people's living standards, people pay more and more attention to health, but with the improvement of living standards, the incidence of cardio...[Details]
The three main limitations of oscilloscopes are: insufficient sensitivity, too small an allowable range of input voltage, and limited bandwidth.
Except for special occasions where signal sensitivity ...[Details]
1. Experimental Purpose Master the steps of using the 51 single-chip microcomputer development board; Master the installation process of the software required for the 51 MCU development board; Take...[Details]
Recently, Changan Automobile launched a thermal imaging epidemic prevention vehicle - CS75PLUS equipped with a military-grade AI intelligent thermal imaging temperature measurement system. And from M...[Details]
The first and second industrial revolutions were both energy revolutions, and the third industrial revolution is a digital revolution. What kind of sparks will be created if the energy revolution a...[Details]
Thanks to the platform strategy, traditional automakers are not gradually launching models one by one on their electrification path, but are able to develop multiple models on multiple platforms at t...[Details]
There are many steps in the packaging of LEDs, and each step will be introduced in detail below.
1. Production process
1. Production:
a) Cleaning: Use ultrasonic cleaning...[Details]
The official website’s iPhone 12 series has already opened for pre-order, but many friends are still taking a wait-and-see attitude, and a big part of the reason is definitely the price. We have pu...[Details]
Switching mode DC/DC regulators have low heat dissipation on densely packed system circuit boards. However, the rapid switching of currents, poorly defined layouts, placement and selection of compo...[Details]
A German business representative recently stated that as a German transportation solution provider, Siemens Mobility has high hopes for the rapid development of China's 5G technology and autonomous d...[Details]
Recently, 12 200KVA 660V to 380V energy storage isolation transformers from Zhuoerfan Transformer Company were shipped to Tianjin. These transformers will provide stable power sup...[Details]
PCB Design
京公网安备 11010802033920号
EEWORLD
