5.0 mm x 3.2 mm Package Pinout ............................................................................................................................................... 1
Ordering Information .................................................................................................................................................................... 2
Device Configurations and Pin-outs ............................................................................................................................................. 9
Pin-out Top Views................................................................................................................................................................. 9
Test Circuit Diagrams for LVCMOS and Clipped Sinewave Outputs ......................................................................................... 10
Frequency Stability ............................................................................................................................................................. 16
Output Frequency and Format............................................................................................................................................ 16
Output Frequency Tuning ................................................................................................................................................... 16
Pin 1 Configuration (OE, VC, or NC) .................................................................................................................................. 17
Control Voltage Bandwidth ................................................................................................................................................. 20
Pull Range and Average Pull Range .................................................................................................................................. 22
Output Frequency ............................................................................................................................................................... 23
2
I C Control Registers .......................................................................................................................................................... 25
Serial Interface Configuration Description .......................................................................................................................... 28
Serial Signal Format ........................................................................................................................................................... 28
Parallel Signal Format ........................................................................................................................................................ 29
Parallel Data Format ........................................................................................................................................................... 29
2
I C Timing Specification ...................................................................................................................................................... 31
2
I C Device Address Modes ................................................................................................................................................. 32
Schematic Example ............................................................................................................................................................ 33
Dimensions and Patterns ........................................................................................................................................................... 34
Additional Information ................................................................................................................................................................ 36
Revision History ......................................................................................................................................................................... 37
Rev 1.05
Page 3 of 38
www.sitime.com
SiT5156
1 MHz to 60 MHz, ±0.5 to ±2.5 ppm, Elite Platform™ Super-TCXO
Electrical Characteristics
All Min and Max limits are specified over temperature and rated operating voltage with 15 pF output load unless otherwise
stated. Typical values are at 25°C and 3.3V Vdd.
Table 1. Output Characteristics
Parameters
Nominal Output Frequency Range
Operating Temperature Range
Symbol
F_nom
T_use
Min.
1
-20
-40
-40
Frequency Stability over
Temperature
Initial Tolerance
Supply Voltage Sensitivity
F_stab
–
–
–
F_init
F_Vdd
–
–
–
–
Output Load Sensitivity
F_load
–
–
–
Frequency vs. Temperature Slope
ΔF/ΔT
–
–
–
Dynamic Frequency Change during
Temperature Ramp
One-Year Aging
20-Year Aging
F_dynamic
–
–
–
F_1y
F_20y
–
–
Typ.
–
–
–
–
–
–
–
–
±7.10
±11.83
±28.40
±0.81
±1.35
±3.24
±15
±25
±60
±0.13
±0.21
±0.50
±1
±2
Max.
60
+70
+85
+105
±0.5
±1.0
±2.5
±1
±16.25
±32.50
±65.0
±2.75
±5.50
±11.00
±25
±50
±100
±0.21
±0.42
±0.83
–
–
Unit
MHz
°C
°C
°C
ppm
ppm
ppm
ppm
ppb
ppb
ppb
ppb
ppb
ppb
ppb/°C
ppb/°C
ppb/°C
ppb/s
ppb/s
ppb/s
ppm
ppm
Initial frequency at 25°C at 48 hours after 2 reflows
Programmers have high salaries and good working environments, and are a profession that many students aspire to, making many non-computer science majors envious. Does that mean non-computer science ma...
[i=s]This post was last edited by jinglixixi on 2022-2-28 22:48[/i]The function of the environmental status detection device is to detect the temperature, humidity, air pressure and light intensity of...
1. Introduction
This article contains a lot of content, but it is actually not difficult. The official tutorial only takes more than ten minutes to explain it. It can be said to be a fool-proof tutori...
Problem description:
1. Prerequisite: In addition to through holes, other blind or buried hole types have been added in the Drill Pair Manager. 2. Set the default via: Set the default via and the corr...
According to news on December 22, Funeng Technology recently received a notice from Jiangxi Jiangling Group New Energy Vehicle Co., Ltd. (hereinafter referred to as "JMC New Energy") "agreeing to car...[Details]
On the morning of February 5, there were rumors that Apple will launch a virtual reality headset (VR) early next year. Foreign media "The Information" reported some expected details of this dev...[Details]
Overview When using any complex tool management system, the tool setter is one of the most important devices. From basic tool measurement and label printing to high-end network communication and DNC ...[Details]
1. The harm of humidity to electronic components and complete machines Most electronic products require operation and storage under dry conditions. According to statistics, more than 1/4 of defective...[Details]
The calibrated on-chip RC oscillator provides a fixed 1.0, 2.0, 4.0, or 8.0 MHz clock. These frequencies are nominal values at 5V, 25°C. This clock can also be used as the system clock by programmi...[Details]
After two years of record sales, North American
robot
orders fell 30% in 2023, according to a new report from the Association for Advancing Automation (A3). The group said it expects the ec...[Details]
Renesas Electronics Corporation (TSE: 6723), a global supplier of leading semiconductor solutions, and Panthronics AG, a fabless semiconductor company specializing in high-performance wireless produc...[Details]
In the specific testing process, what bandwidth is more appropriate for the oscilloscope?
First, look at the following example.
As can be seen from the above figure, the larger the bandwidth...[Details]
STMicroelectronics' first automotive-grade machine learning solution, SL-AIAID012401V1, consists of the AEKD-AICAR1 evaluation kit, AI artificial intelligence plug-in, and AutoDevKit automotive-gr...[Details]
In October 1985, the ±500 kV Gezhouba-Shanghai DC transmission project started construction. This is my country's first ultra-high voltage DC transmission project. The monopole and bipole were put ...[Details]
An actual digital system is often required to be able to work in a multi-sampling rate state. Multi-rate conversion refers to resampling a signal of a known sampling frequency to convert it into a ...[Details]
Below we introduce four basic program structures 1) Sequential structure * A structure in which program modules or instructions are executed sequentially. 2) Branch structure * The structure of jump...[Details]
1. Overview of Embedded Systems 1. Microprocessor related 1. Architecture a. Von Neumann system Features: Instructions and data share the same data bus Focus: main frequency, cache b. Harvard syste...[Details]
According to foreign media reports, in addition to providing independent products, Wheely-Safe has also launched a series of open platform connected devices, which for the first time connect the inte...[Details]
Allwinner Technology announced that the company held the 19th meeting of the third board of directors on September 26, 2019, reviewed and approved the "Proposal on the Transfer of Part of the Equity ...[Details]
Talking
京公网安备 11010802033920号
EEWORLD
