GUS-TSCA-02-1823-F

introduction Ultra-high frequency (UHF) band radio frequency identification (RFID) near-field reader antenna (NFRA) is attracting much attention due to its potential for application in single-...[Details]

●What parts does a speaker consist of? There are all kinds of speakers on the market, but no matter which one, they are composed of the two most basic parts: the speaker unit (termed as a spe...[Details]

So far, solid-state batteries, which have only been used in laboratories, may become the first thunder of the spring for the automotive industry in 2022. As if overnight, the longing for solid-stat...[Details]

This section describes the interrupt handling of the ATmega88. For more general AVR interrupt handling, see P11 “Reset and Interrupt Handling”. (Click on the image to enlarge) Notes: 1. When the fu...[Details]

　　At the current stage, the oscilloscope is not only used to observe waveforms during debugging, but more importantly, it can measure some parameters well to help everyone optimize the design plan. T...[Details]

Intelligent electromagnetic flowmeters are easily affected by noise because their induced signal voltage is very small. Therefore, the flowmeter must have a good grounding. Generally, flowmeters are ...[Details]

I have been busy studying and porting U-boot these days. There is an important step in the process of porting U-boot, which is to set the clock of s3c2440. The clock signals such as Fin, Fclk, Hclk, ...[Details]

Expert advice 　　When you first start learning microcontrollers, you must understand some digital circuits. If you are not familiar with the general concepts of digital circuits, you should learn d...[Details]

Abstract: This paper introduces the design of a four-story elevator control system based on FPGA. The system uses Altera's CycloneⅡ series FPGA chip EP2C5T144 as the main control chip, and uses Ver...[Details]

Overview Modern RF instruments have impressive measurement capabilities and accuracy that far exceed those of their predecessors. However, these instruments cannot reach their full potential without ...[Details]

There are three trigger modes in the oscilloscope: auto, signal, and normal. The "triggering" of the oscilloscope is to synchronize the scanning of the oscilloscope with the observed signal, so as to...[Details]

Electric Vehicles If you haven’t driven an electric vehicle (EV) yet, including hybrid electric vehicles (HEVs), plug-in hybrid electric vehicles (PHEVs), and all-electric vehicles...[Details]

According to foreign media reports, Aira, a developer of innovative wireless power technology, said it would apply its technology to automobiles. Recently, the company announced that it had received ...[Details]

0 Introduction The PID control method can achieve zero-error tracking for step signals, but its tracking performance for the sinusoidal signal output by the inverter power supply ...[Details]

『New Product Release』 Common Mode Semiconductor launches GM1400, a 40V/300mA low power, low noise LDO regulator that can replace ADI's ADP7142, LT1962, LT1521, LT3060 and other products...[Details]