Features ....................................................................................................................................................................................... 1
Typical Phase Jitter (70 fs RMS) and Phase Noise Data ............................................................................................................. 2
Ordering Information .................................................................................................................................................................... 3
LVPECL and FlexSwing Termination .................................................................................................................................. 19
LVDS, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V ...................................... 20
HCSL, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V ...................................... 20
Low-power HCSL, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V .................... 20
Dimensions and Patterns ― 2.0 x 1.6 mm x mm ....................................................................................................................... 21
Dimensions and Patterns ― 2.5 x 2.0 mm x mm ....................................................................................................................... 22
Dimensions and Patterns ― 3.2 x 2.5 mm x mm ....................................................................................................................... 23
Revision History ......................................................................................................................................................................... 24
Rev 0.54
Page 4 of 25
www.sitime.com
SiT9501
Ultra-low Jitter Differential XO for Standard Networking Frequencies
Electrical Characteristics
ADVANCED
All Min and Max limits in the Electrical Characteristics tables are specified over operating temperature and rated operating
voltage with standard output termination shown in the termination diagrams. Typical values are at 25°C and nominal
supply voltage.
Table 3. Electrical Characteristics – Common to All Output Signaling Types
Parameter
Output Frequency Range
Symbol
f
Min.
Typ.
Max.
Unit
MHz
Condition
Refer to frequencies listed in
Error! Not a valid result for table.
s
ection.
Inclusive of initial tolerance, operating temperature, rated power
supply voltage, load variation of 15 pF
±
10%, and 10 years
aging at 25°C
Inclusive of initial tolerance, operating temperature, rated power
supply voltage, load variation of 15 pF
±
10%, and first year aging
at 25°C
Ambient temperature of 25°C
Extended commercial, ambient temperature
Industrial, ambient temperature
Ambient temperature
Extended industrial, ambient temperature
Voltage-supply order code “YY”
Voltage-supply order code “XX”
Voltage-supply order code “18”.
Contact SiTime
for 1.5 V
Voltage-supply order code “25”
Voltage-supply order code “33”
Pins 1 and 2 for OE and SE, respectively
Pins 1 and 2 for OE and SE, respectively
Pins 1 and 2 for OE and SE, respectively
See
Figure 6
and
Figure 8
Measured from the time Vdd reaches its rated minimum value
Measured from the time OE pin toggles to enable logic level to
the time clock pins reach 90% of swing. See
Figure 13
Measured from the time OE pin toggles to disable logic level to
the last clock edge. See
Figure 14
12 kHz to 20 MHz offset frequency integration bandwidth
As an energy conversion device working in the switching state, the voltage and current change rate of the switching power supply is very high, and the interference intensity generated is relatively la...
In the previous article, I used the four user buttons on the kit to change the display color of the RGB LED. In addition to the four user buttons, there are four capacitive touch buttons on the kit:I ...
[i=s] This post was last edited by Woxinyongyong on 2020-11-27 17:22[/i]About CH32V103:
The CH32V103 series is a 32-bit general-purpose microcontroller with RISC-V 3A processor as the core. The proces...
Abstract: This article introduces how to use the MODBUS to PROFIBUS fieldbus gateway to achieve communication between Siemens S7-300PLC and Honeywell DCS system.
1. Composition and implementation meth...
[i=s] This post was last edited by Mengxin on 2019-2-18 13:59 [/i] K60's question: Why does Putty not respond to the serial port printing characters? (I have checked many times that the interface numb...
describe
The board is a complete miniature wireless receiver solution in a SFF (Small Form Factor) form factor. The output is 5Vdc (1A) and can be used to power or charge battery powered devices using...
The emergence of frequency converters has brought innovation to industrial automation control and motor energy saving. Frequency converters are almost indispensable in industrial production. Even i...[Details]
Precautions: Make sure that DM9000 does not exist in the kernel of the development board (when compiling the kernel, choose to compile DM9000 as a module) If you install it on a development board tha...[Details]
The serial port communication of the 51 single-chip microcomputer is full-duplex, which means that it can receive and send at the same time without affecting each other. The serial port can receive...[Details]
When Huawei Mate X was first announced, it was equipped with Kirin 980 processor. Later, due to various reasons, the product launch was delayed. However, in a recent event held by Huawei, foreign med...[Details]
2020 may be the most special year since the iPhone was launched. This is the second time that Apple has released two new iPhones in one year (the last time was in 2016). The new product for the fir...[Details]
On the afternoon of October 20, Yongkang City held a concentrated start-up ceremony for major projects. Zhang Xusheng, secretary of the municipal party committee, announced the concentrated start o...[Details]
The format of the LDR instruction is:
LDR {condition} destination register memory address
Function: Transfer 4 consecutive bytes (1 word) of data at the address pointed to by the memo...[Details]
1 Introduction
For high-precision sensors, temperature error has become a serious obstacle to improving their performance, especially in applications where the ambient temperature changes ...[Details]
The Semiconductor Equipment Association of Japan (SEAJ) released statistics on May 26 showing that Japan's chip equipment sales in January-April 2022 increased by nearly 40% (37%) year-on-year to 122...[Details]
International Energy Network/Photovoltaic Headlines (PV-2005) learned that on April 12, the State Power Investment Corporation Material Equipment Branch and Dianengyiguo (Beijing) Technology Co., L...[Details]
With the deep integration and innovation of communication technology, artificial intelligence, Internet and other technologies in the automotive field, the automotive industry is undergoing a histori...[Details]
The latest developments show that the boundaries between technology and automobile manufacturing are blurring again. Baidu's IDG and Geely Automobile have joined hands to integrate Baidu's self-dev...[Details]
On November 3, the Second Photovoltaic Innovation and Development Promotion Forum was held in Wuxi, Jiangsu. The China General Certification Center (CGC) issued certification certificates to the fi...[Details]
The motor's moment of inertia is an important parameter in motor design, which is related to the motor's starting, braking, operating stability, and control performance. This article will introduce...[Details]
Power technology
京公网安备 11010802033920号
EEWORLD
