Features .......................................................................................................................................................................................1
Ordering Information .....................................................................................................................................................................2
Dimensions and Patterns ― 3.2 x 2.5 mm .................................................................................................................................14
Dimensions and Patterns ― 5.0 x 3.2 mm .................................................................................................................................14
Dimensions and Patterns ― 7.0 x 5.0 mm .................................................................................................................................15
Additional Information .................................................................................................................................................................16
Revision History ..........................................................................................................................................................................17
Rev 1.07
Page 3 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Electrical Characteristics
Table 2. Electrical Characteristics – Common to LVPECL, LVDS and HCSL
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage with standard
output termination shown in the termination diagrams. Typical values are at 25°C and nominal supply voltage.
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
220.000001
-15
-25
-35
-50
Operating Temperature Range
T_use
-20
-40
-40
-40
Supply Voltage
Vdd
2.97
2.70
2.52
2.25
Pull Range
Upper Control Voltage
Lower Control Voltage
Control Voltage Input Impedance
Control Voltage Input Bandwidth
Pull Range Linearity
Frequency Change Polarity
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Start-up Time
OE Enable/Disable Time
PR
VC_U
VC_L
VC_z
V_c
Lin
–
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
Typ.
–
–
–
–
–
–
–
–
–
3.30
3.00
2.80
2.50
Max.
725
+15
+25
+35
+50
+70
+85
+95
+105
Supply Voltage
3.63
3.30
3.08
2.75
V
V
V
V
ppm
Vdd
Vdd
MΩ
kHz
%
–
–
30%
-
55
3.0
3.8
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value.
f = 322.265625 MHz. Measured from the time OE pin reaches
rated VIH and VIL to the time clock pins reach 90% of swing
and high-Z. See
Figure 9
and
Figure 10
Pin 2, OE
Pin 2, OE
Pin 2, OE logic high or logic low
Contact SiTime
for other input bandwidth options
See the APR (Absolute Pull Range)
Table 11.
Contact SiTime
for custom pull range options
Voltage at which maximum frequency deviation is guaranteed
Voltage at which minimum frequency deviation is guaranteed
Unit
MHz
ppm
ppm
ppm
ppm
°C
°C
°C
°C
Extended Industrial
Extended Commercial
Industrial
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated
power supply voltage, load variations, and first year aging
at 25°C, with VIN voltage at Vdd/2.
±15
ppm is only guaranteed for pull range up to
±100
ppm.
Frequency Range
Frequency Stability
Temperature Range
Voltage Control Characteristics
±25, ±50, ±80, ±100, ±150, ±200,
±400, ±800, ±1600, ±3200
90%
–
–
–
–
–
–
10
10
–
Positive Slope
–
–
100
–
–
–
–
10%
–
–
1.0
Input Characteristics
Output Characteristics
Startup and OE Timing
Rev 1.07
Page 4 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
RMS Period Jitter
[4]
RMS Phase Jitter (random)
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
–
0.220
0.270
ps
Min.
–
–
–
–
Vdd-1.15
Vdd-1.9
1.2
–
–
Typ.
–
–
0.15
–
–
–
1.6
225
1.0
Max.
97
63
–
32
Vdd-0.7
Vdd-1.5
2.0
290
1.6
Unit
mA
mA
A
mA
V
V
V
ps
ps
Condition
Excluding Load Termination Current, Vdd = 3.3 V or 2.5 V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 5
See
Figure 5
See
Figure 6
20% to 80%, see
Figure 6
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 156.25 or 322.265625 MHz, IEEE802.3-2005 10 GbE jitter
mask integration bandwidth = 1.875 MHz to 20 MHz,
all Vdd levels
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 322.265625 MHz, IEEE802.3-2005 10 GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, all Vdd levels
How to test wire length using LOTO oscilloscope TDR method?
TDR is time-domain reflectometer , which can measure the length of the wire by observing the waveform of the electrical signal reflected fro...
[i=s]This post was last edited by Aguilera on 2019-3-10 12:36[/i] [size=4]When you can compile a UART communication program that can realize communication on a standard MSC51 microcontroller, the prob...
Live broadcast time: October 20 (Thursday) 10:00-11:30 am
Live Topic: TE Connectivity's Smart Building Solutions - Sensing and Connectivity, the Key to Smart Building DesignWatch LiveLive Broadcast In...
Author: Huang Gang, a member of Yibo Technology Expressway MediaPCB engineer: "There are no more layers to go. These pairs of 10G signals need to change layers several times and make four vias before ...
On January 20, the Shenzhen Regulatory Bureau disclosed Jinyuan Securities' registration information on the initial public offering and listing guidance of Shenzhen Jingyan Kejie Technology Co., Ltd....[Details]
According to news on January 12, TSMC released its fourth quarter earnings report today, with revenue of NT$625.53 billion (currently approximately 138.868 billion yuan) and net profit of NT$295.9 bi...[Details]
U.S. chipmaker Globalfoundries sued TSMC for using its patented chip technology and asked the U.S. International Trade Commission (ITC) to impose an import ban, which could have a market impact and a...[Details]
Renesas Electronics Corporation (TSE: 6723), a premier supplier of semiconductor solutions, today announced new power and functional safety solutions for R-Car V3H system-on-chip (SoC)-based systems ...[Details]
After three years, the 23rd China International Expo (CIIF) returned to the National Exhibition and Convention Center (Shanghai) from September 19th to September 23rd! With the theme of "Carbon Rec...[Details]
Recently, the whistleblower @数码闲聊站 exposed the specifications of the Redmi Note 9 5G high-end version. The whistleblower showed that this is a modified version of the Xiaomi 10T Lite, but with a diff...[Details]
introduction This paper mainly studies the problem of voltage sag control. For sensitive load equipment with rectifier inverter structure, this paper proposes a DC dynamic voltage restorer (Dynam...[Details]
On the morning of October 29, data agency IDC recently released a report stating that supply chain shortages ultimately affected the global smartphone market, causing global mobile phone shipme...[Details]
This paper develops an intelligent and efficient digital power supply system based on the characteristics of the pico-satellite power supply system. Its intelligent design is mainly reflected in: r...[Details]
When an ARM exception interrupt occurs, the system will jump to the corresponding exception interrupt handler after executing the current instruction. When the exception interrupt handler is executed...[Details]
The circuit is shown in Figure 1. The circuit is mainly composed of five parts: oscillation, boost, rectification, triggering and discharge output. R1, C1, R2, D1, D2 and VT and L1, L2 form an osci...[Details]
/*34864 Chinese character library*/ // Connection of MCU //******************************************************** //p3= data port //p4--control port// p4.0 = rs //p4.1= r/w //p4.2= e //...[Details]
1 Introduction With the rapid development of mobile communications, the development of low-frequency spectrum resources has become very mature. The remaining low-frequency spectrum resources can no l...[Details]
Pan Jingdong, Chairman and Party Secretary of State Grid Hebei Electric Power Co., Ltd.
At the 2019 mid-year work conference of State Grid Corporation of China, Chairman Kou Wei's report furth...[Details]
Test/Measurement
京公网安备 11010802033920号
EEWORLD
