Moisture Sensitivity Level (MSL) – This product is Hermetically Sealed and
not Moisture Sensitive - MSL = N/A: Not Applicable
FEATURES:
• Suitable for RoHS compliant reflow
• Low height reduced to 3.3mm
• Available suitable for thin equipment
• Tight stability & extended temperature
Reduced height
to 3.3mm
Pb
RoHS
Compliant
11.4 x 4.7 x 3.3 mm
APPLICATIONS:
• Computers, Modems, Microprocessors
• Wireless Applications
STANDARD SPECIFICATIONS:
PARAMETERS
Parameters
Minimum
3.579545
Typical
-----
-----
-----
Maximum
24.00
50.00
70.00
Units
Notes
Fundamental AT
(Standard)
Fundamental AT or BT
(See options)
3
rd
Overtone
(Standard)
)
Frequency Range
24.01
24.01
MHz
Operation Mode
Operating Temperature
Storage Temperature
Frequency Tolerance @+25°C
Frequency Stability over the Operating
Temperature ( ref. to +25°C)
Equivalent series resistance (R1)
Shunt capacitance (C0)
Load capacitance (CL)
Drive Level
Aging
Insulation Resistance
Drive level dependency (DLD)
Fundamental or 3
rd
Overtone
0
-----
+70
-55
-----
+125
-50
-----
+50
-50
-----
-----
-----
-5
-----
See table 1 below
-----
18
100
-----
+50
7
-----
1000
+5
ºC
ºC
ppm
ppm
Ω
pF
pF
µW
ppm
See options
See options
See options
(For BT cut, ±100ppm max.at
-10° C to +60° C only)
Standard
(See options if
other than STD)
500
-----
-----
MΩ
Minimum 7 points tested: from 1µW to 500µW.
Change in frequency (Maximum - Minimum) over DLD range < ±10ppm
Change in ESR (Maximum - Minimum) over DLD range < 25% of Max ESR
value.
Maximum ESR over DLD range < Max ESR value.
ESR (Ω)
180
120
100
80
60
50
40
100
80
REVISED: 11.15.2016
5101 Hidden Creek Lane Spicewood TX 78669
Phone: 512-371-6159 | Fax: 512-351-8858
For terms and conditions of sale please visit:
www.abracon.com
ABRACON IS
ISO9001-2008
CERTIFIED
@25°C±3°C
First year
@ 100Vdc ± 15V
TABLE 1: ESR
FREQUENCY (MHz)
3.579545 - 4.999 (Fund.)
5.000 - 5.999 (Fund.)
6.000 - 7.999 (Fund.)
8.000 - 8.999 (Fund.)
9.000 - 9.999 (Fund.)
10.000 - 15.999 (Fund.)
16.000 - 50.000 (Fund.)
24.01 - 31.999 (3rd O/T)
32.000 - 70.00 (3rd O/T)
LL C
HC/ 49US (AT49) LOW PROFILE SURFACE
MOUNT MICROPROCESSOR CRYSTAL
ABLS2
Pb
RoHS
Compliant
Options and Part Identification
(left blank if standard)
Reduced height
to 3.3mm
11.4 x 4.7 x 3.3 mm
| | | | | | | | | | | | | | |
ABLS2 -
Frequency in MHz
Please specify the frequency
in MHz. e.g. 14.31818MHz
MHz -
-
-
-
-
Packaging
Blank: Bulk
T: Tape&Reel
Oscillation Mode
F: Fund. AT>24MHz
FB: Fund. BT>24MHz
Load Capacitance (pF)
Please specify CL
(Minimum 10pF) in pF or
S for series
Custom ESR if other
than standard
R□
□:
Specify a value in
Ω
(e.g.: R40)
Operating Temp.
A: -10°C ~ +60°C
B: -20°C ~ +70°C
C: -30°C ~ +70°C
N: -30°C ~ +85°C
D: -40°C ~ +85°C
J*: -40°C ~ +105°C
K*: -40°C ~ +125°C
L*: -55°C ~ +125°C
Freq. Tolerance
H5: ± 5 ppm
1: ± 10 ppm
7: ± 15 ppm
2: ± 20 ppm
3: ± 25 ppm
4: ± 30 ppm
Freq. Stability
U**: ± 10 ppm
G: ± 15 ppm
X: ± 20 ppm
W: ± 25 ppm
Y: ± 30 ppm
H: ± 35 ppm
Q: ± 100 ppm
R: ± 150 ppm
NOTE: Fundamental BT frequency stability ± 100ppm max. at -10° C to +60° C only.
* Frequency stability ±50ppm, ±100ppm, ±150ppm only. Contact ABRACON for tighter frequency stability.
** Contact ABRACON for availability of ±10ppm with other Operating Temperature options.
LL C
5101 Hidden Creek Lane Spicewood TX 78669
Phone: 512-371-6159 | Fax: 512-351-8858
For terms and conditions of sale please visit:
www.abracon.com
REVISED: 11.15.2016
ABRACON IS
ISO9001-2008
CERTIFIED
HC/ 49US (AT49) LOW PROFILE SURFACE
MOUNT MICROPROCESSOR CRYSTAL
ABLS2
Pb
RoHS
Compliant
OUTLINE DRAWING:
Reduced height
to 3.3mm
11.4 x 4.7 x 3.3 mm
| | | | | | | | | | | | | | |
TAPE & REEL:
T = tape and reel (1000pcs/reel)
Reflow Profile
Zone
1
2
3
Description
Preheat
Temperature
T
SMIN
~ T
SMAX
150°C ~ 180°C
T
L
230°C
Time
60 ~ 120 sec.
30 ~ 40 sec.
10 sec. MAX
Peak Heat
T
P
260°C
Dimensions: mm
ATTENTION:
Abracon products are COTS - Commercial-Off-The-Shelf products; suitable for Commercial, Industrial and, where designated, Automotive Applications.
Abracon’s products are not specifically designed for Military, Aviation, Aerospace, Life-dependant Medical applications or any application requiring high reliability where component
failure could result in loss of life and/or property. For applications requiring high reliability and/or presenting an extreme operating environment, written consent and authorization
from Abracon is required. Please contact Abracon for more information.
Hello, everyone~ The last issue of the "DIY Creative Show Based on USB PD Power Protocol Chip CH224" jointly launched by EEWorld and Qinheng ended successfully with everyone's active participation, an...
Recently, the dissolution of Baidu's enterprise software division has attracted media attention and many suspicions. Yesterday, Baidu issued a statement, saying that there is enough evidence to prove ...
We use the command "vi Makefile" to enter the Makefile. As shown in Figure 1:Add the following content.Change TARGET to "key" in line 2.Add the GPIO and key driver header file path to the variable INC...
[i=s]This post was last edited by jinglixixi on 2022-2-16 12:08[/i]The GD32L233C is equipped with a corresponding temperature detection channel, and the on-chip temperature can be detected with the he...
[NXP Rapid IoT Review] Rapid IoT Studio Simple Programming Step 4 Add Bluetooth RGB Light Control [font="]1. Add RGB light control control to the Rapid IoT Studio Simple Programming Step 2 Counter Add...
[i=s]This post was last edited by szkei on 2020-8-14 22:41[/i]First, the previous article used the LCD library function to display the Olympic five-color rings and the pictures of Hetai evaluation. Po...
0 Introduction The temperature and humidity of the high-voltage room in the substation have an important impact on the safe operation of the equipment. At present, the Weinan power grid requires...[Details]
Recently, scientists at the Fraunhofer Institute in Aachen developed a new OLED production method for Philips, which is said to effectively reduce the waste of raw materials.
Before this techn...[Details]
On December 31, 2019, OPPO Vice President Shen Yiren could not contain his excitement and announced a blockbuster news. He said: "Happy New Year to everyone in advance! The next time we meet will pro...[Details]
On August 17, the official website of the China Association of Automobile Manufacturers released a notice soliciting opinions on the group standard "Specifications for the Construction of Shared El...[Details]
On September 9, the first IC Innovation and Entrepreneurship Development Forum of the "Core Power" Talent Program was held in Nanjing Jiangbei New District. At the meeting, Zhang Pengfei, Chairman of...[Details]
Huawei's internal website Xinsheng Community published a document from Huawei's management team (EMT) (Huawei EMT Resolution No. 007). The document is titled "Resolution on the Management of Smart C...[Details]
In modern driving safety systems, the headlight control system plays an important role. According to records, most traffic accidents occur at night or in bad weather. Among these traffic accidents, m...[Details]
introduction Wind energy is a clean and renewable energy source. Wind power generation is one of the most mature and promising power generation methods among new energy sources . With the developmen...[Details]
How 5G open RAN small cells will improve security and flexibility and accelerate the deployment of next-generation network technologies
With the advent of the 5G era, the network is ...[Details]
Improving fuel efficiency with a starter
Denso has released the "tandem solenoid starter" (hereinafter referred to as TS starter) (Figure 15), which is used in the new diesel car "XF" of J...[Details]
A digital multimeter is an electronic instrument that must be used in electrical measurements. Its main function is to measure voltage, resistance and current. Whether you are an electrician, a perso...[Details]
According to a report by Kyodo News on February 6, Japan’s Ministry of Economy, Trade and Industry announced on the 6th that it will provide subsidies for the plan to mass-produce cutting-edge storag...[Details]
At Embedded World Expo today, Renesas Electronics announced a new entry-level MCU family in the RA Series. All About Circuits spoke with Masashi Ueda of Renesas Electronics to learn more.
...[Details]
The automotive gateway controller is a core component in the vehicle's electronic and electrical architecture. As the data interaction hub of the vehicle network, it can route CAN, LIN, MOST, FlexRay...[Details]
Let me first state a conclusion: the current automobile market is driven by new energy, and the core growth of the new energy market relies on hybrid power.
Data shows that in 2023, my c...[Details]