5.0 mm x 3.2 mm Package Pinout ............................................................................................................................................... 1
Ordering Information .................................................................................................................................................................... 2
Device Configurations and Pin-outs ............................................................................................................................................. 9
Pin-out Top Views................................................................................................................................................................. 9
Test Circuit Diagrams for LVCMOS and Clipped Sinewave Outputs ......................................................................................... 10
Frequency Stability ............................................................................................................................................................. 16
Output Frequency and Format............................................................................................................................................ 16
Output Frequency Tuning ................................................................................................................................................... 16
Pin 1 Configuration (OE, VC, or NC) .................................................................................................................................. 17
Control Voltage Bandwidth ................................................................................................................................................. 20
Pull Range and Average Pull Range .................................................................................................................................. 22
Output Frequency ............................................................................................................................................................... 23
2
I C Control Registers .......................................................................................................................................................... 25
Serial Interface Configuration Description .......................................................................................................................... 28
Serial Signal Format ........................................................................................................................................................... 28
Parallel Signal Format ........................................................................................................................................................ 29
Parallel Data Format ........................................................................................................................................................... 29
2
I C Timing Specification ...................................................................................................................................................... 31
2
I C Device Address Modes ................................................................................................................................................. 32
Schematic Example ............................................................................................................................................................ 33
Dimensions and Patterns ........................................................................................................................................................... 34
Additional Information ................................................................................................................................................................ 36
Revision History ......................................................................................................................................................................... 37
Rev 1.05
Page 3 of 38
www.sitime.com
SiT5156
1 MHz to 60 MHz, ±0.5 to ±2.5 ppm, Elite Platform™ Super-TCXO
Electrical Characteristics
All Min and Max limits are specified over temperature and rated operating voltage with 15 pF output load unless otherwise
stated. Typical values are at 25°C and 3.3V Vdd.
Table 1. Output Characteristics
Parameters
Nominal Output Frequency Range
Operating Temperature Range
Symbol
F_nom
T_use
Min.
1
-20
-40
-40
Frequency Stability over
Temperature
Initial Tolerance
Supply Voltage Sensitivity
F_stab
–
–
–
F_init
F_Vdd
–
–
–
–
Output Load Sensitivity
F_load
–
–
–
Frequency vs. Temperature Slope
ΔF/ΔT
–
–
–
Dynamic Frequency Change during
Temperature Ramp
One-Year Aging
20-Year Aging
F_dynamic
–
–
–
F_1y
F_20y
–
–
Typ.
–
–
–
–
–
–
–
–
±7.10
±11.83
±28.40
±0.81
±1.35
±3.24
±15
±25
±60
±0.13
±0.21
±0.50
±1
±2
Max.
60
+70
+85
+105
±0.5
±1.0
±2.5
±1
±16.25
±32.50
±65.0
±2.75
±5.50
±11.00
±25
±50
±100
±0.21
±0.42
±0.83
–
–
Unit
MHz
°C
°C
°C
ppm
ppm
ppm
ppm
ppb
ppb
ppb
ppb
ppb
ppb
ppb/°C
ppb/°C
ppb/°C
ppb/s
ppb/s
ppb/s
ppm
ppm
Initial frequency at 25°C at 48 hours after 2 reflows
1. Network Overview
Building a complete Zigbee mesh network includes two steps: network initialization and node joining the network. Node joining the network includes two steps: joining the network ...
[table=98%] [tr][td]I would like to ask a question: If I comment out this line of code, UART2_Send_1Byte(res);, the ESP8266 WIFI module cannot be initialized; but if I add UART2_Send_1Byte(res);, it c...
as follows:
code u8 STB1[][3]={};
code u8 STB2[][3]={};code u8 code *std[]={STB1,STB2}; This worked in 51 before, but there was a problem when ported to 32 (code has been changed to const). Error mess...
[i=s]This post was last edited by gs001588 on 2022-1-22 22:43[/i][Evaluation of domestic FPGA Gaoyun GW1N-4 series development board]——12. Two tips (multi-function pins and board silk screen)Tips (1):...
This is my first time to use CAN bus. Recently, I need to send and receive data through CAN bus. When I use microcontroller to send ID=0x401, I check the waveform and find that the actual data sent is...
Knowledge point 1: pointer
1. Pointer: The first number of the variable's storage space in memory is called the address of the variable, also called a pointer.
Pointer variable: It is used to store a ...
In the development of power sources for portable electronic products, batteries are undoubtedly the only choice for power sources. Based on the considerations of environmental protection and reu...[Details]
in conclusion: My understanding is that multiple data is transmitted at a time, no matter your data is 8 bits, 16 bits or 32 bits, which is equivalent to the amount of data buffered in the receivi...[Details]
In order to implement the decisions and arrangements of the CPC Central Committee and the State Council on further deepening the reform of the power system and the price mechanism, continue to prom...[Details]
/**********************************************************************
* File name: main.c
* Program author: kidcao1987
* Program version: V1.0
* Function description: There is an LED light in th...[Details]
Messe München Group officially announced today that the world-renowned electronics industry Olympic event, the Munich Electronics Show (electronica) in Germany, will officially set up a Shenzhen st...[Details]
Humans survive because their hearts keep beating; the same is true for vacuum cleaners. Only when the "heart" is in good condition can they vacuum better. In order to ensure the continuous and normal ...[Details]
On November 20, under the guidance of the Zhongguancun Forum Office and hosted by Intel China Research Institute, the 2023 Zhongguancun Forum series of activities and the Intel Intelligent Healthcare...[Details]
There is no shortcut to becoming a master in the world, but some basic principles can be followed.
1. Solid foundation
Data structures, discrete mathematics, and compiler theory are the foundatio...[Details]
TI's
TPS40210
and
TPS40211
are wide input voltage (4.5V-52V) current mode asynchronous boost controllers with programmable soft start, overcurrent protection with automatic rest...[Details]
In digital circuits, we often encounter logic circuits, and in C language, we often use logical operations. The two are interrelated in principle. First of all, within the concept of "logic", there...[Details]
Outdoor lighting has been widely used in many demonstration projects at home and abroad. Due to its harsh use environment, the design of outdoor LED lighting driver power supply must focus on evaluat...[Details]
An investor asked on the investor interaction platform: What is the progress of Darui Electronics' Suzhou project? How is the production of the IPO-raised investment project going? Will it have a pos...[Details]
With the upgrading of detection technology, the measurement accuracy and stability of electromagnetic flowmeters have been greatly enhanced. At present, it has become a widely used flow measurement de...[Details]
Recently,
Gasgoo Automotive Research Institute
released the "Smart Cockpit Configuration Data List from January to August 2024", including seven major areas such as cockpit domain control, ...[Details]
Servo systems are an indispensable part of modern industrial automation and precision control. According to different control methods, servo systems can be divided into open-loop servo systems, clo...[Details]
Wireless Connectivity
京公网安备 11010802033920号
EEWORLD
