Moisture Sensitivity Level (MSL) – This product is not Moisture Sensitive - MSL = 1
11.5 x 5.0 x 13.46mm
| | | | | | | | | | | | | | |
STANDARD SPECIFICATIONS:
Parameters
Frequency Range
Operation Mode
Operating Temperature
Storage Temperature
Frequency Tolerance @+25°C
Frequency Stability over the
operating temperature ( ref. to
+25°C)
Equivalent series resistance (R1)
Shunt capacitance (C0)
Load capacitance (CL)
Drive Level
Aging@25°C±3°C
Insulation Resistance
Drive level dependency (DLD),
minimum 7 points tested: from
1µW to 500µW.
0
-55
-50
-100
See table 1 below
Minimum
1.8432
Typical
Maximum
Units
MHz
1.8432MHz – 24.000MHz
24.01MHz – 66.00MHz
66.01MHz – 122.00MHz
122.01MHz – 160.00MHz
See options
See options
See options
Notes
160.000
Fundamental
3
rd
Overtone
5
th
Overtone
7
th
Overtone
+70
+125
+50
+100
ºC
ºC
ppm
ppm
Ω
7
pF
18
pF
100
1000
µW
±5
ppm
500
M
Ω
Change in frequency (Maximum - Minimum) over
DLD range < ±10ppm;
Change in ESR (Maximum - Minimum) over DLD
range < 25% of Max ESR value;
Maximum ESR over DLD range < Max ESR value.
See options
First year
@100Vdc±15V
Table 1
FREQUENCY (MHz)
1.8432-1.999
2.000-2.399
2.400-2.999
3.000-3.699
3.700-4.199
4.200-4.899
4.900-5.999
6.000-7.999
8.000-9.999
10.000-12.499
12.50-50.00
24.00-66.00
66.01-122.00
122.01-160.00
Operation Mode
ESR
(Ω)
max
750
550
350
200
100
70
50
40
35
30
25
40
80
120
HC49/U
Fundamental
HC49/U (3rd OT)
HC49/U (5th OT)
HC49/U (7th OT)
LLC
5101 Hidden Creek Lane Spicewood TX 78669
Phone: 512-371-6159 | Fax: 512-351-8858
For terms and conditions of sale please visit:
www.abracon.com
REVISED: 01.05.2017
ABRACON IS
ISO9001-2008
CERTIFIED
HC49/U CRYSTAL
AB
OPTIONS AND PART IDENTIFICATION:
(Left blank if standard)
Pb
RoHS/RoHS II Compliant
11.5 x 5.0 x 13.46mm
| | | | | | | | | | | | | | |
AB -
Frequency in MH z
Please specify the frequency
in x x .x x x x M Hz.
e .g . 14.3181MHz
MHz -
-
-
-
-
-
-
P a c k a g in g
Blank: Bulk (std.)
T: Tape & Reel
(For MJ option only)
Q u a lit y F a c t o r * * *
Minimum
QXXXk
Value
L o a d Capacit anc e (pF)
Please specify CL
(Minimum 10 pF) in pF or
S fo r series
Custo m E SR if other
than st a n d a r d
R□
□: Specify
a value in
Ω
(e .g .: R40)
Operating Temp.
A: -10°C ~ + 60° C
B: -20°C ~ + 70° C
C: -30°C ~ + 70° C
N: -30°C ~ + 85° C
D: -40°C ~ + 85° C
Valu e Added
I
V
QXX
MJ
Operation Mode
Fund. AT > 24MHz
F
FB
O
Freq. Tolerance
1: ± 10 pp m
7: ± 15 pp m
2: ± 20 ppm
3: ± 25 ppm
4: ± 30 ppm
Freq . St abilit y
Option s fo r A T -
Cut only *
U * * : ± 1 0 p pm
G: ± 15 ppm
X: ± 20 ppm
W : ± 25 ppm
Y: ± 30 ppm
H: ± 35 ppm
Z: ± 5 0 p pm
Table 2
CODES
Q45
Q40
Q35
Q30
Q25
Q20
Q15
Q10
Q115
TRIMMED L in(mm)
0.45 (11.43)
0.40 (10.16)
0.35 (8.89)
0.30 (7.62)
0.25 (6.35)
0.20 (5.08)
0.15 (3.81)
0.10 (2.54)
0.115 (2.92)
NOTE: Use appropriat e code numbers for
other trimmed lengths not liste d.
(e.g. Q14 for 0.14 inch (3.55 mm))
Fund. BT>24MHz
3rd OT>66MHz
Insulator Tab
Vinyl Sleeve
T rimmed lea ds
See Ta ble 2
Metal jacket
NOTE:
*:Fr equency Stability ± 100
ppm max at -10 to +60C only
for BT cut.
** : -10 to +60C only.
*** : Quality factor must be
ac companied by a k value
LLC
5101 Hidden Creek Lane Spicewood TX 78669
Phone: 512-371-6159 | Fax: 512-351-8858
For terms and conditions of sale please visit:
www.abracon.com
REVISED: 01.05.2017
ABRACON IS
ISO9001-2008
CERTIFIED
HC49/U CRYSTAL
AB
OUTLINE DRAWING:
Insulator Tab
For Option I
Pb
RoHS/RoHS II Compliant
11.5 x 5.0 x 13.46mm
| | | | | | | | | | | | | | |
Vinyl Sleeve
For Option V
Dimensions: inch (mm)
LLC
5101 Hidden Creek Lane Spicewood TX 78669
Phone: 512-371-6159 | Fax: 512-351-8858
For terms and conditions of sale please visit:
www.abracon.com
REVISED: 01.05.2017
ABRACON IS
ISO9001-2008
CERTIFIED
HC49/U CRYSTAL
AB
OUTLINE DIMENSION CONTD...
Metal Jacket Formed Leads
For Option MJ
Pb
RoHS/RoHS II Compliant
11.5 x 5.0 x 13.46mm
| | | | | | | | | | | | | | |
T 1,000 pcs/reel
Dimensions: mm
TAPE & REEL:
T: 1,000 pcs/reel
Tape and reel packaging applies only to MJ (metal jacket) option
E
1.75±0.10
E2
22.25 MIN.
F
11.5±0.10
P2
2.00±0.10
ØD0
1.50±0.10
P0
4.00±0.10
W
24.00±0.30
Dimensions: mm
ATTENTION:
Abracon products are COTS – Commercial-Off-The-Shelf products; suitable for Commercial, Industrial and, where designated, Automotive Applications.
Abracon’s products are not specifically designed for Military, Aviation, Aerospace, Life-dependant Medical applications or any application requiring high reliability where
component failure could result in loss of life and/or property. For applications requiring high reliability and/or presenting an extreme operating environment, written consent and
authorization from Abracon is required. Please contact Abracon for more information.
Smart Sports WatchAuthor: hehung1. Introduction
This work is a smart sports watch, which can realize time, alarm, stopwatch, step counting, Bluetooth reminder, temperature and humidity, air pressure a...
hehungonsemi and Avnet IoT Innovation Design Competition
1. People with thick palmsPeople with generous personalities are good at talking and spending money, and people with thick palms are generous in spending money. People with this kind of palms usually ...
[i=s]This post was last edited by qi777ji on 2021-5-24 11:02[/i]Today I read the section on PCB design of transconductance amplifier. Regarding the protection ring of the op amp, when a weak signal is...
Assuming you have been tasked with designing a monitor circuit for a new battery-based power system, what strategies would you adopt to optimize the cost and manufacturability of the design? The init...[Details]
AC test equipment usually requires a low-distortion signal source to stimulate the device under test. A common approach is to use a signal generator to generate a low-distortion reference signal an...[Details]
Power amplifier, referred to as "power amplifier". In many cases, the rated output power of the host is not enough to drive the entire audio system. At this time, a power amplifier must be installe...[Details]
In recent years, domestic MPUs have become more and more powerful, and the chips are localized, no longer purely dependent on imports. The product platform selection is independent and controllable...[Details]
ASTM International recently announced its latest personnel appointment. Andrew G. Kireta Jr. will become the new president, succeeding Katharine Morgan, who has served as president of ASTM Internat...[Details]
Intel's central processing unit (CPU) 7nm advanced process has been unable to reach its established shipment target. In contrast, its rival AMD has relied on TSMC's 7nm advanced process technology to...[Details]
The design idea of the digital power supply made this time is nothing new. It is just a digital-to-analog converter (ADC0809) and an analog-to-digital converter (DAC0832), plus two single-chip micr...[Details]
Blood pressure (BP) refers to the lateral pressure exerted on the blood vessel wall per unit area when blood flows in the blood vessels. It is the driving force for blood to flow in the blood vessels...[Details]
According to a report by market research firm Omdia*1, Infineon Technologies AG (FSE: IFX/OTCQX: IFNNY) has successfully taken the lead in the MEMS microphone market. According to the MEMS chip sales...[Details]
In recent years, due to the impact of the epidemic, wearing masks when going out has become a normal part of everyone's life for health reasons, but it is not user-friendly for some mobile devices th...[Details]
1. Basic analysis steps for field instrument system failure Field instrument measurement parameters are generally divided into four major parameters: temperature, pressure, flow, and liquid level. No...[Details]
Connect an external crystal oscillator and then generate a clock source through the internal circuit
Directly use the external clock source
Select by setting the pin
FCLK cpu
HCLK AHB
...[Details]
On July 18, the first energy storage station in Zhejiang Province, the Hangzhou Yuhang Future Science and Technology City lithium battery energy storage project, undertaken by China Energy Construc...[Details]
We know that the current enterprise WLAN architecture includes centralized data forwarding and control, redundant centralized data forwarding and control, centralized control and distributed forwardi...[Details]
1. Differences in structure The pixels of the passive drive matrix are composed of a simple substrate with a cathode and an anode. The intersection of the anode and the cathode can emit light, and t...[Details]
onsemi and Avnet IoT Innovation Design Competition
京公网安备 11010802033920号
EEWORLD
