Features ....................................................................................................................................................................................... 1
Ordering Information .................................................................................................................................................................... 2
LVPECL and FlexSwing Termination .................................................................................................................................. 17
LVDS, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V ...................................... 18
HCSL, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V ...................................... 18
Low-power HCSL, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V.................... 18
Dimensions and Patterns ― 2.0 x 1.6 mm x mm ....................................................................................................................... 19
Dimensions and Patterns ― 2.5 x 2.0 mm x mm ....................................................................................................................... 20
Dimensions and Patterns ― 3.2 x 2.0 mm x mm ....................................................................................................................... 21
Revision History ......................................................................................................................................................................... 22
Rev 0.53
Page 3 of 23
www.sitime.com
SiT9375
Low Jitter Differential XO for Standard Networking Frequencies
Electrical Characteristics
ADVANCED
All Min and Max limits in the Electrical Characteristics tables are specified over operating temperature and rated operating
voltage with standard output termination shown in the termination diagrams. Typical values are at 25°C and nominal
supply voltage.
Table 3. Electrical Characteristics – Common to All Output Signaling Types
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
–
Min.
Typ.
Max.
Unit
MHz
ppm
Condition
Refer to frequencies listed in
Ordering Information
section.
Inclusive of initial tolerance, operating temperature, rated power
supply voltage, load variation of 15 pF
±
10%, and 10 years
aging at 25°C
Inclusive of initial tolerance, operating temperature, rated power
supply voltage, load variation of 15 pF
±
10%, and first year aging
at 25°C
Ambient temperature of 25°C
Extended commercial, ambient temperature
Industrial, ambient temperature
Ambient temperature
Extended industrial, ambient temperature
Voltage-supply order code “YY”
Voltage-supply order code “XX”
Voltage-supply order code “18”.
Contact SiTime
for 1.5 V
Voltage-supply order code “25”
Voltage-supply order code “33”
Pins 1 and 2 for OE and SE, respectively
Pins 1 and 2 for OE and SE, respectively
Pins 1 and 2 for OE and SE, respectively
See
Figure 5
and
Figure 7
Measured from the time Vdd reaches its rated minimum value
Measured from the time OE pin toggles to enable logic level to
the time clock pins reach 90% of swing. See
Figure 12
Measured from the time OE pin toggles to disable logic level to
the last clock edge. See
Figure 13
12 kHz to 20 MHz offset frequency integration bandwidth,
156.25 MHz
12 kHz to 20 MHz offset frequency range, 156.25 MHz
12 kHz to 20 MHz offset frequency range, 155.52 MHz
156.25 MHz
156.25 MHz
Frequency Range
Standard frequencies
–
±20
Frequency Stability
–
–
–
10 Year Aging
Operating Temperature Range
F_10y
T_use
–
-20
-40
-40
-40
Supply Voltage
Vdd
1.71
2.25
1.71
2.25
2.97
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Startup Time
Output Enable Time
Output Disable Time
VIH
VIL
Z_in
DC
T_start
T_oe
T_od
70%
–
–
45
–
–
–
–
–
–
±1
–
–
–
–
–
–
1.80
2.50
3.30
–
–
100
–
1
–
–
±25
±30
±50
–
+70
+85
+95
+105
ppm
ppm
ppm
ppm
°C
°C
°C
°C
V
V
V
V
V
Temperature Range
Supply Voltage
3.63
3.63
1.89
2.75
3.63
Input Characteristics
–
Vdd
30%
–
55
5
100+3 clock
cycles
100+3 clock
cycles
Vdd
kΩ
%
ms
ns
ns
Output Characteristics
Startup, OE and SE Timing
Jitter and Phase Noise
RMS Phase Jitter (random)
Spurious Phase Noise
RMS Period
Jitter
[1]
Jitter
[1]
T_phj
PN_spur_a
PN_spur_b
T_jitt_per
T_jitt_cc
Peak Cycle-to-cycle
–
–
–
–
–
200
-110
-80
1
6
–
–
–
–
–
fs
dBc
dBc
ps
ps
Note:
1. Measured according to JESD65B.
Rev 0.53
Page 4 of 23
www.sitime.com
SiT9375
Low Jitter Differential XO for Standard Networking Frequencies
ADVANCED
Table 4. Electrical Characteristics – LVPECL
|
Supply voltages: 2.5 V
±10%,
3.3 V
±10%,
2.25 V to 3.63 V
Parameter
Current Consumption, Output
Enabled without Termination
Current Consumption, Output
Enabled with Termination 1
Current Consumption, Output
Enabled with Termination 2
Current Consumption, Output
Disabled without Termination
Current Consumption Output
Disabled with Termination 1
Current Consumption, Output
Disabled with Termination 2
OE Leakage Current
Symbol
Idd_oe_nt
Idd_oe_wt1
Idd_oe_wt2
Idd_od_nt
Idd_od_wt1
Idd_od_wt2
I_leak
Min.
–
–
–
–
–
–
–
Typ.
43
52
71
58
58
86
37
Max.
–
–
–
–
–
–
–
Unit
mA
mA
mA
mA
mA
mA
mA
Condition
Excluding load termination current
Including load termination current. See
Figure 15
for
termination
Including load termination current. See
Figure 18
for
termination
Excluding load termination current
Including load termination current. See
Figure 15
for
termination
Including load termination current. See
Figure 18
for
termination
OE = disable logic, DC termination, OUTP and OUTN held
Battery test equipment DC power system design : https://training.eeworld.com.cn/course/5293This video highlights the TI Wide Vin DC/DC Controller and devices from Precision Analog devices as a solutio...
High-performance dimming electronic ballast solution, a product jointly developed by IXYS and Atmel500 ) {this.resized=true; this.width=500; this.alt='This is a thumbnail, click to enlarge. Press CTRL...
[b][align=center][size=17px]Now, whenever you open the SoC original PCB Layout Guide, you will find that the corner angle of high-speed signal routing will be mentioned. They will say that high-speed ...
The program download design of the 51 single-chip microcomputer hardware design is shown in the figure, but the program cannot be burned in, the single-chip microcomputer cannot be detected, and the v...
1 Introduction Visual inspection technology is a new test technology based on machine vision. It is popular because of its characteristics of non-contact measurement, fast speed, large amount of infor...
The serial port interrupt of PIC16F15324 microcontroller cannot be entered. Please give me some advice. The program is configured by MCC. The serial port can send data normally, but the interrupt cann...
Varistor is a resistor commonly used in electronic components. It has a wide range of applications, including power supply systems, security systems, household appliances and other fields. However,...[Details]
On June 6, the Ministry of Industry and Information Technology officially issued 5G commercial licenses, which means that my country will officially enter the first year of 5G commercialization. Ne...[Details]
1. Ammeter Ammeter (Figure 1) is divided into two types: DC ammeter and AC ammeter. When using the ammeter, pay attention to selecting the correct range and connect it in series in the measured pract...[Details]
1. Place the meter in a horizontal position and check whether the pointer of the galvanometer is on the base line. If not, use the zero adjuster to adjust it to the base line. 2. Set the "multiplie...[Details]
Recently, some media broke the news that OPPO is developing an independent image processing chip (ISP). As early as October 2019, OPPO established a chip technology committee and named the self-devel...[Details]
At a time when the world is shrouded in the shadow of the virus, people who have been forced to press the pause button have gradually calmed down and started to seriously reflect on the relationship ...[Details]
In view of the characteristics of electrical control products, this paper discusses several design methods of commonly used input/ output circuits of single-chip microcomputers , which has practical ...[Details]
Latest storage pyramid architecture Storage Pyramid v1 and Speed understanding-arm-documentation Instruction cycle timings are described in the TRM Size of caches/TLBs is described in the TRM Th...[Details]
Hongqi's new pure electric flagship SUV, the E115 (code name) concept car, was released as early as last year's Frankfurt Motor Show. Its exterior design adopts Hongqi's iconic family design style. T...[Details]
Truck crime is on the rise in Europe, with a truck being hacked into every 23 minutes in the UK. In 2019, insurance claims for theft increased by more than 50%, with British merchants losing £264 mil...[Details]
As we all know, JZ2440 V2 is very compact. Today we will discuss some issues regarding the JZ2440 serial port. When we use the serial port for debugging, we need to use a USB cable that comes with th...[Details]
0 Introduction
The multi-MCU DC power supply control board includes A/D acquisition and conversion, measurement, display, synchronization, automatic phase sequence determination, phase shift tr...[Details]
When electromagnetic flowmeters are measuring liquids, there will be many bubbles, which often lead to errors in flowmeter measurement and affect its use.
Generally, the fluid measured by elect...[Details]
For the indoor LED display, take the Ф3.75 (unit board specifications: 304mm*152mm, specifications: 64*32 dots) model as an example.
If you want to make a LED display screen with a length of ...[Details]
In the field of industrial automation, ABB robots, as an advanced automation equipment, are widely used in manufacturing, logistics, medical and other fields. However, during use, the ABB robot pro...[Details]
Talking
京公网安备 11010802033920号
EEWORLD
