Features .......................................................................................................................................................................................1
Ordering Information .....................................................................................................................................................................2
Dimensions and Patterns ― 3.2 x 2.5 mm .................................................................................................................................14
Dimensions and Patterns ― 5.0 x 3.2 mm .................................................................................................................................14
Dimensions and Patterns ― 7.0 x 5.0 mm .................................................................................................................................15
Additional Information .................................................................................................................................................................16
Revision History ..........................................................................................................................................................................17
Rev 1.07
Page 3 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Electrical Characteristics
Table 2. Electrical Characteristics – Common to LVPECL, LVDS and HCSL
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage with standard
output termination shown in the termination diagrams. Typical values are at 25°C and nominal supply voltage.
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
220.000001
-15
-25
-35
-50
Operating Temperature Range
T_use
-20
-40
-40
-40
Supply Voltage
Vdd
2.97
2.70
2.52
2.25
Pull Range
Upper Control Voltage
Lower Control Voltage
Control Voltage Input Impedance
Control Voltage Input Bandwidth
Pull Range Linearity
Frequency Change Polarity
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Start-up Time
OE Enable/Disable Time
PR
VC_U
VC_L
VC_z
V_c
Lin
–
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
Typ.
–
–
–
–
–
–
–
–
–
3.30
3.00
2.80
2.50
Max.
725
+15
+25
+35
+50
+70
+85
+95
+105
Supply Voltage
3.63
3.30
3.08
2.75
V
V
V
V
ppm
Vdd
Vdd
MΩ
kHz
%
–
–
30%
-
55
3.0
3.8
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value.
f = 322.265625 MHz. Measured from the time OE pin reaches
rated VIH and VIL to the time clock pins reach 90% of swing
and high-Z. See
Figure 9
and
Figure 10
Pin 2, OE
Pin 2, OE
Pin 2, OE logic high or logic low
Contact SiTime
for other input bandwidth options
See the APR (Absolute Pull Range)
Table 11.
Contact SiTime
for custom pull range options
Voltage at which maximum frequency deviation is guaranteed
Voltage at which minimum frequency deviation is guaranteed
Unit
MHz
ppm
ppm
ppm
ppm
°C
°C
°C
°C
Extended Industrial
Extended Commercial
Industrial
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated
power supply voltage, load variations, and first year aging
at 25°C, with VIN voltage at Vdd/2.
±15
ppm is only guaranteed for pull range up to
±100
ppm.
Frequency Range
Frequency Stability
Temperature Range
Voltage Control Characteristics
±25, ±50, ±80, ±100, ±150, ±200,
±400, ±800, ±1600, ±3200
90%
–
–
–
–
–
–
10
10
–
Positive Slope
–
–
100
–
–
–
–
10%
–
–
1.0
Input Characteristics
Output Characteristics
Startup and OE Timing
Rev 1.07
Page 4 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
RMS Period Jitter
[4]
RMS Phase Jitter (random)
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
–
0.220
0.270
ps
Min.
–
–
–
–
Vdd-1.15
Vdd-1.9
1.2
–
–
Typ.
–
–
0.15
–
–
–
1.6
225
1.0
Max.
97
63
–
32
Vdd-0.7
Vdd-1.5
2.0
290
1.6
Unit
mA
mA
A
mA
V
V
V
ps
ps
Condition
Excluding Load Termination Current, Vdd = 3.3 V or 2.5 V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 5
See
Figure 5
See
Figure 6
20% to 80%, see
Figure 6
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 156.25 or 322.265625 MHz, IEEE802.3-2005 10 GbE jitter
mask integration bandwidth = 1.875 MHz to 20 MHz,
all Vdd levels
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 322.265625 MHz, IEEE802.3-2005 10 GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, all Vdd levels
I want to use CC2541 to make a remote control with 10 buttons, low power sleep, and external interrupt wake-up.
I have a question, the STM32 external interrupt IO port numbers cannot be repeated. For ...
[align=left]As the carrier of various components and the hub of circuit signal transmission, PCB has become the most important and critical part of electronic information products. Its quality and rel...
1. Open the mfgtools_for_6ULL folder and find the cfg.ini file. If your board is EMMC, modify it as shown in Figure 1:If your board is NAND, modify it as shown in Figure 2:2. Open the "Profiles\Linux\...
Voltage comparators began to appear in microcontrollers in the late 1990s. At the time, it was considered a technology that only reduced costs. Because such comparators required less silicon and en...[Details]
1. Circuit Design This circuit consists of AT89C51 minimum system, 74HC595 shift register, 8*8 dot matrix LED screen and buttons. 74HC595 displacement register 74HC595 is an 8-bit serial input and ...[Details]
H.264/AVC is a new generation of video coding standard jointly launched by ISO/IEC and ITU-T. It has the advantages of high compression rate, high image quality, good network affinity, etc., and i...[Details]
On November 29, the first 5MW/15MWh user-side energy storage project in Xuancheng, Anhui Province was successfully connected to the grid. The project was provided with system integration solutions ...[Details]
The advancement of electrification, driven by the demands for automation, convenience and sustainability, requires more sensors, power electronics and processors to reliably and accurately se...[Details]
1. Hardware pin introduction: This test uses SPI mode to read and write SD cards, and the relevant pin configurations are as follows: Chip select: SD_CS- PB13, corresponding to pin 1 of SD card, lo...[Details]
With one and a half months to go before the flexible direct current system was energized, Xu Dangguo hung the "debugging schedule" in the project meeting room. He had a clear understanding of the b...[Details]
If the and
of a two-port network are given
,
and the and
are obtained
, the port characteristic equation of the two-port network is:
(5-5-1)
The above fo...[Details]
With the advent of the era of intelligent manufacturing, the global manufacturing industry is ushering in a new round of industrial transformation. As a major manufacturing country in the world, Chin...[Details]
In recent years, with the accelerated development of intelligence, electrification and networking, cars are transforming from a single means of transportation to a third space that integrates leisu...[Details]
Multimedia processors are often the most power-hungry devices in portable electronic devices. Common ways to reduce CPU power requirements are to reduce clock frequency or operating voltage, but th...[Details]
Compared with street lamps using traditional light sources (such as high-pressure sodium lamps and metal halide lamps), LED street lamps have the advantages of no need for preheating, frequent swit...[Details]
In today's highly competitive mobile phone industry, mobile phone manufacturers, in order to compete for more market share, have given their phones a variety of special features to attract users, and...[Details]
Figure 1 PWM logic circuit and output circuit
In Figure 1, V8 is the oscillation pulse generated by the oscillation circuit, and its duty cycle is 50%. The pulse determines the operating fr...[Details]
(Cai Jiangang and Pang Yanjuan) The Baiyangdian Lake is surrounded by blue waters, and the thousand-year-old forest is sprouting green. The development of Xiong'an New Area has accelerated again. S...[Details]
Linux and Android
京公网安备 11010802033920号
EEWORLD
