Features ....................................................................................................................................................................................... 1
Ordering Information .................................................................................................................................................................... 2
Revision History ......................................................................................................................................................................... 15
Rev 0.5
Page 2 of 18
www.sitime.com
SiT9347
220 MHz to 725 MHz Endura™ Series Ultra-low Jitter Differential Oscillator
Electrical Characteristics
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage
with standard output termination shown in the termination diagrams. Typical values are at 25°C at nominal supply voltage.
Table 2. Electrical Characteristics – Common to LVPECL, LVDS and HCSL
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
220.000001
-10
Typ.
–
–
Max.
725
+10
Unit
MHz
ppm
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated power
supply voltage and load variations.
Contact SiTime
for ±10 ppm.
Inclusive of initial tolerance, operating temperature, rated power
supply voltage and load variations
Frequency Range
Frequency Stability
-20
-25
-50
First Year Aging
10 Year Aging
20 Year Aging
F_1y
F_10y
F_20y
-0.7
-1.4
-1.6
–
–
–
±0.4
±0.8
±1.0
+20
+25
+50
+0.7
+1.4
+1.6
ppm
ppm
ppm
ppm
ppm
ppm
At 85°C
At 85°C
At 85°C
Temperature Range
Operating Temperature Range
T_use
-20
-40
-40
-40
Acceleration (g) sensitivity,
Gamma Vector
Supply Voltage
F_g
–
–
–
–
+70
+85
+95
+105
°C
°C
°C
°C
Extended Industrial
Low sensitivity grade; total gamma over 3 axes; 15 Hz to 2 kHz; MIL-
PRF-55310, computed per section 4.8.18.3.1
Extended Commercial
Industrial
Rugged Characteristics
–
–
0.1
ppb/g
Supply Voltage
Vdd
2.97
2.70
2.52
2.25
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Startup Time
OE Enable/Disable Time
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
3.30
3.00
2.80
2.50
–
–
100
–
–
–
3.63
3.30
3.08
2.75
–
30%
-
55
3.0
3.8
V
V
V
V
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value.
f = 322.265625 MHz. Measured from the time OE pin reaches rated
VIH and VIL to the time clock pins reach 90% of swing and high-Z.
See
Figure 8
and
Figure 9
Pin 1, OE
Pin 1, OE
Pin 1, OE logic high or logic low
Input Characteristics
Output Characteristics
Startup and OE Timing
Rev 0.5
Page 2 of 18
www.sitime.com
SiT9347
220 MHz to 725 MHz Endura™ Series Ultra-low Jitter Differential Oscillator
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
RMS Period Jitter
[3]
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
Min.
–
–
–
–
Vdd-1.15
Vdd-2.0
1.2
–
–
–
Typ.
–
–
0.15
–
–
–
1.6
225
1.0
0.220
Max.
94
63
–
33
Vdd-0.7
Vdd-1.5
2.0
330
1.6
0.270
Unit
mA
mA
A
mA
V
V
V
ps
Ps
Ps
Condition
Excluding Load Termination Current, Vdd = 3.3V or 2.5V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 4
See
Figure 4
See
Figure 5
20% to 80%, see
Figure 5
f = 100, 156.25 or 212.5 MHz, Vdd = 3.3V or 2.5V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz, all
Vdd levels, includes spurs. Temperature ranges -20 to 70ºC and
-40 to 85ºC.
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs. Temperature ranges -40 to 95ºC and
-40 to 105ºC
f = 322.265625 MHz, IEEE802.3-2005 10GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, Includes spurs, all
Vdd levels
f = 100, 156.25 or 212.5 MHz, Vdd = 3.3V or 2.5V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz, all
Vdd levels, includes spurs. Temperature ranges -20 to 70ºC and
-40 to 85ºC.
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs. Temperature ranges -40 to 95ºC and
-40 to 105ºC
f = 322.265625 MHz, IEEE802.3-2005 10GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, Includes spurs, all
China's vibrant printed circuit industry 2006-6-23 Printed circuit board (PCB) is a substrate for assembling electronic components and parts. After decades of development, especially after the build-...
1. OSDFPGA configures a dedicated 8-bit register to control the indicator light on and off. The access address is 90080017h. It can be seen from the circuit diagram that the low level lights up.2. Whe...
2.4 Kalman filter initialization Initialization is also very important. Large initialization deviation may lead to vibration or even failure of convergence (?). [/color][/size][/font][/align][align=le...
First of all, this is an advanced circuit knowledge question, not a brain teaser.
For small signals in the frequency range of 100Hz--100kHz, what basic component does the op amp correspond to?...
The biggest technical highlight of 2021 is whether the two 800V models to be launched by Hyundai and Kia can stand out in Europe and South Korea. There are two highlights here: whether the fast charg...[Details]
With the increasing performance of embedded microprocessor chips, embedded devices have been widely used. With the expansion of applications, embedded software development has also shown the c...[Details]
0 Introduction
This paper applies the timer function of WDM in
redundancy technology
, provides a solution for system fault detection and switching technology, and takes the dual redun...[Details]
Any equipment has its own life cycle. At the late stage of the equipment life cycle, the equipment will inevitably age, experience reduced efficiency, and experience more failures, which is not con...[Details]
In the era of fuel vehicles, we pay close attention to the power combination of engine and gearbox.
Entering the era of electric drive, although people are still concerned about the vehicle's ...[Details]
In the blink of an eye, 2016 will soon become a thing of the past. The 2017 CES Electronics Show will be held in Las Vegas from January 5 to January 7. In addition to traditional electronic devices, ...[Details]
1. The inverter external relay controls the forward and reverse circuit
2. Power on the inverter (button SB2)
3. Forward (SB4)
4. Reverse (SB6, KA2 and KA1 form an ...[Details]
Recently, developer Kacper Skrzypek discovered traces of Xiaomi 11i and Xiaomi 11i HyperCharge in the database. Kacper Skrzypek pointed out that the Xiaomi 11i series is a new product that Xia...[Details]
Ford reveals future design direction
In mid-March, Ford announced the future direction of interior design, with brain scanning and eye tracking technology becoming the latest design tools. ...[Details]
According to phonearena, insider Evan Blass revealed that an official media rendering clearly shows the front panel design of Google Pixel 4. This leaked rendering reveals a "mysterious" date - ...[Details]
On March 2, 2021, a digital blogger revealed that Wu Dezhuo, president of ByteDance's New Stone Lab, had resigned and joined Sharklet. In response, Wu Dezhuo said the revelation was true. Wu Dezhou...[Details]
Optical switches are important functional components of optical communication networks, and MEMS optical switches are one of the most promising optical switches. Based on the introduction of the pr...[Details]
The precise test of industrial CT density resolution is usually a concern for both industrial CT manufacturers and their users. There are many test methods for testing the density resolution ability o...[Details]
For a laptop computer that is designed to stand out, it should be slim, and the thinner the better. Of course, the power supply should be the same. But it is very challenging to design a power supp...[Details]
7. Then, right-click "Symbol" and click "Edit PSpice model" to view the PSpice model. A quick look at the text of the model will give you an intuitive idea of how well the symbol pins match the act...[Details]
PCB Design
京公网安备 11010802033920号
EEWORLD
