EEWORLDEEWORLDEEWORLD

Part Number

Search

PH1-MLPFA3881

Description
Transponder, 10709Mbps(Tx), 10709Mbps(Rx), FC/UPC Connector,
CategoryWireless rf/communication    Optical fiber   
File Size240KB,6 Pages
ManufacturerLumentum Operations LLC
Download Datasheet Parametric View All

PH1-MLPFA3881 Overview

Transponder, 10709Mbps(Tx), 10709Mbps(Rx), FC/UPC Connector,

PH1-MLPFA3881 Parametric

Parameter NameAttribute value
MakerLumentum Operations LLC
Reach Compliance Codecompli
Other featuresIT ALSO OPERATE FROM 1280NM TO 1600NM
body width56.1 mm
body height13.2 mm
Body length or diameter76.5 mm
Connection TypeFC/UPC CONNECTOR
Data rate (receive)10709 Mbps
Data rate (send)10709 Mbps
Emitter/Detector TypePIN PHOTODIODE
Fiber optic equipment typesTRANSCEIVER, TRANSPONDER
Nominal operating wavelength1554 nm
Nominal optical power output1.584 mW
minimum return loss-27 dB
Sensitivity-17 dBm
COMMUNICATIONS MODULES & SUBSYSTEMS
10 Gb/s TDM/DWDM 300 Pin SFF MSA SR2/IR2/LR2 Transponder
PH1 Series
Key Features
• Three configurations supporting SR2/IR2/LR2 applications
• Supports dense wavelength division multiplexing
(DWDM) applications (without wavelocker)
• Microprocessor controls to support I2C
• Integrated 16:1/1:16 mux/demux
• Small form factor package (2.2" x 3.0" x 0.53") for high
density applications
• Low power consumption: 4.8 W typical, 6.8 W maximum
for TDM applications
• 70 °C maximum operating temperature
• High sensitivity PIN or APD receivers
• SONET, FEC, Ethernet and Multirate Capable Versions
• Forward, counter and line timing clocking modes
Applications
Telecommunications
Metropolitan Area Networks
Subscriber loop
Intra-office SONET/SDH
High bit-rate data communications
JDSU 10 Gb/s PH1 Series transponders are intended for 1550 nm system
applications with reaches of up to 80 km. The series includes three different
transponders for SR2 (25 km), IR2 (40 km), and LR2 (80 km) TDM or DWDM
applications. Each transponder accepts 16 bits of parallel digital data and converts
it to a 10 Gb/s NRZ modulated optical signal. It also accepts a 10 Gb/s NRZ
modulated optical signal and converts it into 16 bit wide parallel digital data.
The PH1 series offers low DC power dissipation and is available in either a small
form factor package (2.2 x 3 x 0.53 inches) or in a larger footprint (3.5 x 4.5 x 0.53
inches) package, depending on system thermal performance requirements. The
transmit design uses an Electro-Absorptive Modulated Laser (EML) which,
depending on the configuration, produces an average output power of between
-4 dBm to 2 dBm (EOL). A PIN (-17 dBm typical sensitivity) or APD (-24 dBm
typical sensitivity) receiver is available, based on system configurations.
JDSU PH1 Series transponders are designed to support the following data rates:
9.953 Gb/s (SONET), 10.3125 Gb/s (Ethernet), 10.664 Gb/s (FEC Encoded),
10.709 Gb/s FEC, or 11.09 Gb/s EFEC. They meet all applicable SONET/SDH standards.
Compliance
• Telcordia GR-253-Core
NORTH AMERICA
:
800 498-JDSU (5378)
WORLDWIDE
:
+800 5378-JDSU
WEBSITE
:
www.jdsu.com
Happy Queen's Day
Today is Queen's Day, happy holiday to all the female compatriots in the forum! Have the male compatriots in the forum prepared surprises for the female compatriots at home?...
okhxyyo Talking
What are the main differences between DSP's C language and host's C language?
What are the main differences between DSP's C language and host's C language? 1) The C language of DSP is standard ANSI C, which does not include the extended parts that are connected to peripherals, ...
fish001 DSP and ARM Processors
14 "Wanli" Raspberry Pi car - motor drive learning
The Raspberry Pi motor driver expansion board uses the PCA9685 chip, which is an I2C to 16-channel PWM chip, and then uses 8 of the PWMs to control four AT8236 chips, which is a motor driver chip. Tha...
lb8820265 Innovation Lab
Help 200VDC-DC to 5V power management chip
[i=s]This post was last edited by Xiao Liuzi on 2022-4-2 10:23[/i]I have a project that requires 200V DC to be stepped down to 5V through DC-DC. What DC-DC power management chip solutions are recommen...
肖柳子 Switching Power Supply Study Group
The kernel of the free version of rt-thread is really too bad...
[i=s]This post was last edited by freebsder on 2022-4-25 23:23[/i]I don't know about the paid version, I haven't seen it, so I'll just say the free version. Recently, I need to use some features of RT...
freebsder Embedded System
GPIO internal structure and working principle
1. Introduction to STM32F103ZET61. STM32 physical picture:   2. STM32 pinout diagram:   STM32F103ZET6: 144 pins in total, 7 groups of IO ports, 16 IO ports in each group 7*16=112 IO ports (these 7 gro...
btty038 stm32/stm8

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号