[size=5] There are two ways to match the bus. One is to add matching resistors. A 120Ω matching resistor should be connected between the differential ports VA and VB at both ends of the bus to reduce ...
[i=s] This post was last edited by Feiyangzi at 2019-1-3 13:48 [/i] Following [url=https://en.eeworld.com/bbs/thread-1065909-1-1.html]https://en.eeworld.com/bbs/thread-1065909-1-1.html[/url], we will ...
Want to remotely control the forward, backward, and turning of the electric two-wheeled balance vehicle through broadband or 4G network?
How to achieve this, please give me some advice!!
My thoughts a...
As 5G wireless networks continue to evolve, the performance of the radio front end plays an increasingly critical role in the RF receiver signal path, especially for low noise amplifiers (LNAs). With ...
5.3.1 Android source code overall compilation - based on Xunwei-IMX6 development board seriesThis section introduces how to compile Android source code as a whole, that is, compile uboot, kernel, and ...
The slow express finally arrived at my place. I took it back last night and couldn’t wait to open the package, take out the GD32E503V-EVAL development board I had been looking forward to for a long ti...
RF/Wirelessly
京公网安备 11010802033920号
EEWORLD
