-
#include
void main(void)
{
WDTCTL = WDTPW + WDTHOLD; // Stop watchdog timer
P1DIR |= 0x01; // Set P1...[Details]
-
Steam flow meter calibration method Calibration is carried out according to the calibration principle of steam flow meter. The calibration principle is as follows: In practical applications, th...[Details]
-
S7-1200 V4.0 and above firmware versions of the CPU support intelligent IO device functions, so you can use S7-1200 as an intelligent IO device and S7-300 PN CPU for Profinet communication. In this...[Details]
-
Thermistor Testing
In a typical laser diode module, the thermistor has a nominal resistance of 10 kΩ at 25°C. In normal operating mode, the thermal stability of the entire module is more critical tha...[Details]
-
Han's Laser held the 34th meeting of the 6th Board of Directors and reviewed and approved the "Proposal on Authorizing the Company's Management to Initiate Preliminary Preparations for the Domestic L...[Details]
-
1 Introduction
When an excellent lighting control design is completed, many benefits will be achieved, such as compliance with energy-saving regulations, reduced installation costs, minimal error...[Details]
-
Recently, Huawei announced that it will hold a new product launch conference for whole-house intelligence and smart screens, and will also announce a new smart home strategy. After the mobile phone b...[Details]
-
void X5045SpiOpen(void);//Open the X5045 chip select void X5045SpiClose(void);//Close the X5045 chip select void X5045WriteEnable(void);//Software enables X5045 write operation void X5045WriteDisable...[Details]
-
On the evening of March 20, Chuanyi Technology released its annual performance report, stating that its operating income in 2021 was approximately 1.92 billion yuan, a year-on-year increase of 8.51%;...[Details]
-
Detailed page: http://alanzjl.sinaapp.com/2015/02/gpio_brr_bsrr_odr/ BRR, BSRR, and ODR are all used to control 16-bit pins. Among them, the upper 16 bits of BRR and ODR are unavailable (reserved),...[Details]
-
1. In the project options of avr studio, in the General option, you need to pay attention to the following: edit configuration: This option means that the default output folder of the current proj...[Details]
-
When using an oscilloscope, one of the most basic issues is how to stabilize the displayed waveform. This involves triggering operation, which is a difficult skill to master when using an oscillosc...[Details]
-
Performing measurements in the frequency domain with an MDO (mixed domain oscilloscope) is straightforward and easy to set up. But as with any spectrum analyzer, there are some things you should not f...[Details]
-
Three-phase asynchronous motor Y-△ drag control circuit
1. Description of the star-delta starting control principle of three-phase asynchronous motor
Three-phase asynchronous motors are w...[Details]
-
In early October, at a battery energy storage project construction site in Ben Djali Province in northern Côte d'Ivoire, construction workers were stepping up civil construction. In June 2021, in orde...[Details]
Integrated technical exchanges
京公网安备 11010802033920号
EEWORLD
