Figure 7. Standard PECL Output Configuration Figure 8. Single Resistor Termination Scheme
Resistor values are typically 140 ohms for
3.3V operation.
Resistor values are typically 84 ohms for 2.5V
operation.
The VCC6 incorporates a standard PECL output scheme, which are un-terminated emitters as shown in Figure 7. There are numerous application notes on
terminating and interfacing PECL logic and the two most common methods are a single resistor to ground, Figure 8, and a pull-up/pull-down scheme as
shown in Figure 9. An AC coupling capacitor is optional, depending on the application and the input logic requirements of the next stage.
LVDS Application Diagrams
V
CC
LVDS
Driver
100
LVDS
Receiver
LVDS
Driver
100
Receiver
OUT+
OUT-
Figure 10 Standard LVDS
Output Configuration
Figure 11. LVDS to LVDS Connection, Internal 100ohm
Figure 12. LVDS to LVDS Connection
Some LVDS structures have an internal 100 ohm resistor on the
External 100ohm and AC blocking caps
input and do not need additional components.
Some input structures may not have an internal 100 ohm
resistor on the input and will need an external 100ohm
resistor for impedance matching. Also, the input may have
an internal DC bias which may not be compatible with
LVDS levels, AC blocking capacitors can be used.
One of the most important considerations is terminating the Output and Complementary Outputs equally. An unused output should not be left un-termi-
nated, and if one of the two outputs is left open it will result in excessive jitter on both. PC board layout must take this and 50 ohm impedance matching
into account. Load matching and power supply noise are the main contributors to jitter related problems.
Ultrasonic waves emitted by a 40KHz ultrasonic probe can also have a significant impact on the gyroscope data.
Also, I don’t know if it’s a psychological effect, but I feel like I’m going deaf....
[i=s]This post was last edited by wenyangzeng on 2021-10-31 09:13[/i]Free evaluation - Topmicro intelligent display module (4) displays Chinese charactersThe steps for displaying English strings and C...
On the afternoon of April 13, in the second round of the Tokyo Olympic Women's Football Asian Qualifiers, after overtime, the Chinese women's football team tied with the South Korean women's football ...
I would like to ask if anyone who has used nand flash has encountered a problem and cannot find the cause. At first, the default interface of nand flash is SDR mode. I configured the nand flash interf...
16.1 LCD Controller/Driver FunctionsThe functions of the LCD controller/driver built into the RL78/L13 are as follows:(1) It can select the normal LCD waveform (A waveform, B waveform) or the memory L...
MEMS sensors
京公网安备 11010802033920号
EEWORLD
