Custom performance characteristics are available upon request. Use form C052 to detail
non-standard parameters.
Contact your local CTS Representative or CTS Customer Service for assistance.
* Prior to 11/7/06 the part number format did not contain this designator. These "Old Format" numbers (008-0261-0 Rev. E) are still valid with frequencies less than
or equal to 48.0000 MHz as Fundamental Mode designs. Frequencies above 48.0000 MHz will be Third Overtone designs. Refer to PCM-1211 for more details.
Document No. 008-0261-0
Page 1 - 3
Rev. F
٠ ٠ ٠
CTS Electronic Components, Inc.
٠
171 Covington Drive
٠
Bloomingdale, IL 60108
٠ ٠ ٠
٠ ٠ ٠
www.ctscorp.com
٠ ٠ ٠
7.0x5.0mm Low Cost
Surface Mount Crystal
Model 407
ELECTRICAL CHARACTERISTICS
PARAMETER
Operating Mode
(Note 1)
Crystal Cut
Frequency Range
Frequency Tolerance @ 25°C
Electrical Parameters
VALUE
Fundamental or 3
RD
Overtone
AT-Cut
8.0 MHz to 100.0 MHz
± 30 ppm Standard
(± 10 ppm and ± 20 ppm Available)
Frequency Stability Tolerance
(Operating Temperature Range, Referenced to 25°C Reading)
[i=s] This post was last edited by Cijian Dare Not Be Ahead on 2022-3-14 09:57[/i]Case: Implementing a dial pointer clock - based on TOPWAY intelligent display module (HMT070ETD-1D)Step 1: Use the hos...
Using a 220V to 18V transformer, the voltage output of the transformer output (pins 12, 14, 17, 19) is 12V. After passing through the MB6S rectifier, the output voltage of pin 3 of SP1 is 27V, and the...
[align=center][font=宋体][size=5][color=#0000ff][b]1. LED DC power indicator circuit[/b][/color][/size][/font][/align][font=宋体][size=4][color=#0000ff][b]1. DC LED indicator circuit[/b][/color][/size][/f...