MOS2CVTPA1072F

1 Introduction The core is an important part of the electromagnetic component in the power supply and plays an important role in its performance. The design of the core of the electromagnetic ...[Details]

The Huawei Mate 30 series 5G version will be available for pre-order on the official website at 18:08 this afternoon. A deposit of 1,000 yuan is required, and the balance will be paid at 10:08 am on ...[Details]

　　The circuit shown in Figure 1 is a 10MHz to 6GHz broadband active mixer with an integrated interface for direct connection to a synthesizer-based low phase noise local oscillator (LO). 　　This circu...[Details]

Abstract: LED dot matrix display screen has the characteristics of reliable operation, safety, energy saving, low cost and easy use. This paper discusses the various methods used in the design of L...[Details]

Preface     This article describes a simple power supply solution. It uses synchronous buck conversion controllers such as the TPS56100, TPS5210, TPS56xx and TPS5602, targeting TI's C6000 DSP applic...[Details]

       Since the S3C2440 core board and the main board are made in the laboratory, the H-Jtag of the friendly arm cannot be used, so J-Link is used to test whether the soldered core board works norma...[Details]

Clamp meters and multimeters have their own advantages and disadvantages depending on the places where electricians use them. It is impossible to simply say which one is better or worse than the othe...[Details]

The wave of technological advancement is deeply affecting the automotive industry. Today, cars have transformed from simple means of transportation into mobile living spaces that provide comfortable,...[Details]

introduction   　　Intelligent sensors, which are composed of sensor technology, communication technology and computer technology, have attracted people's attention in process control and signal mo...[Details]

In our daily life, we often encounter such a dilemma: we want to add hand sanitizer or detergent to the dispenser, but end up with liquid on our hands; in the hospital, nurses cannot avoid the nutrie...[Details]

The Science and Technology Innovation Board officially opened on July 22. The establishment of the Science and Technology Innovation Board is another historic breakthrough in the development of my co...[Details]

1 Introduction With the rapid improvement of chip integration, an electronic system or subsystem can be fully integrated on a chip, and the IC industry has formed a design method based on system-on-c...[Details]

Mobile power supplies are also known as power banks and free chargers. In 2004, a few manufacturers in Shenzhen produced them, mainly for export to Europe, the United States, and Japan. They have b...[Details]

In embedded applications, the main reason for using RTOS is to improve system reliability, followed by improving development efficiency and shortening development cycles. μC/OS-II ...[Details]

Materials suitable for laser welding The materials suitable for laser welding are as follows: 　　1. Die steel. 　　S136, SKD-11, NAK80, 8407, 718, 738, H13, P20, W302, 2344 and other steels have goo...[Details]