-
I looked at the clock tree and configured it according to the blog post http://blog.csdn.net/louyangyang91/article/details/51374924. It turned out that the UART baud rate was wrong, but MOC1\2 were a...[Details]
-
Introduction Currently, the main failure form of electronic equipment is thermal failure. According to statistics, 55% of the failures of electronic equipment are caused by the temperature exceeding...[Details]
-
1. The structure and working principle of the megohmmeter: The insulation resistance is measured using a megohmmeter, which is also called an insulation megohmmeter or megohmmeter for short. Common m...[Details]
-
Why does bldc use square wave control
Brushless DC motors (BLDC) use square wave control because square wave control is a simple, economical and effective control method suitable for many appl...[Details]
-
A: First, press the (11) MEASURE button. A list of displayed data will appear on the right side of the screen, as shown in the blue part of the display screen in Figure 1. This means that the oscillo...[Details]
-
Compared with the more eye-catching digital chips, the analog IC market, which has always been low-key, is very profitable. Global analog chip giants TI and ADI make good profits from the analog...[Details]
-
introduction:
At present, photoelectric colorimeters on the market generally communicate with computers through RS232 serial ports. With the development of computer technology, this interf...[Details]
-
1. Power on: Turn on the instrument first , then the computer and software. After powering on, warm up the instrument for half an hour.
2. Click DTS (Nano) software on the desktop to enter the in...[Details]
-
High performance infrared remote control switch circuit
The transmitter uses 555 connected as a multivibrator, the oscillator frequency is 35KHZ, driving the infrared transmittin...[Details]
-
On October 27, Leapmotor officially released its first smart driving chip with completely independent intellectual property rights - "Lingxin 01". 据了解,凌芯01芯片由浙江芯昇电子与零跑汽车共同研发,将搭载于零跑第三款量产车型C11上。零跑C1...[Details]
-
With the changes of the times, more and more new configurations have emerged. Recently, there is another new configuration that is called "useless configuration" by people, but car companies are very...[Details]
-
The working principle of the Hall sensor is based on the Hall effect proposed by Edwin Hall in 1869. The proposed statement says: "The Hall effect is the production of a voltage difference (the Hall ...[Details]
-
The chip model is STM32F103CB (128K). A constant array is defined at address 801F000 in the project. When compiling, an error occurs: ER_IROM1: File exists ........ It is found that the chip model wa...[Details]
-
Looking back, my first encounter with Fourier Transform was when I was studying signals and systems. I thought its mathematical expression was beautiful and wanted to learn more about it. However, ...[Details]
-
Temperature probes and temperature sensors are two different devices that have their own characteristics and application scenarios in measuring temperature. This article will introduce the differen...[Details]