Video signal enhancement circuit
Source: InternetPublisher:酷到被通缉 Keywords: Signal boost circuit Updated: 2024/09/24
The enhancement circuit shown in the figure can increase the high frequency component of the video signal, thereby enhancing the contrast of the TV image. It can also be connected between the output of the video recorder and the SCART input of the TV. The transistor Tl in the circuit acts as a buffer. The resistor Rl ensures that the input impedance of the enhancement circuit is about 75Ω. The signal is added to the amplifier stage T2, and its gain depends on the position of the potentiometer P2. The frequency characteristics of the base signal of T2 are restricted by Pl, R6, and C6, so it can be controlled by the user to a certain extent (through Pl). The buffer stage T3 provides enough current to properly drive most 75Ω loads. Adjust the potentiometer P2 to make the output 1Vp-p (for open-circuit output, the level should be 2Vp-p).
- Band-independent tone adjustment circuit
- Video amplifier circuit: video amplifier board-5
- Single-phase full-wave rectifier inductor filter circuit
- Differential amplifier circuit with a bandwidth of 20MHz
- Variable filter circuit with constant bandwidth
- Current conversion amplifier circuit
- Voice filter circuit using LM387
- 250mA high speed buffer BUF634
- Precision instrument amplifier circuit
- Differential amplifier circuit with adjustable gain and common mode rejection ratio
- How to read amplification circuit diagram
- Adjustment and testing of RC bridge oscillation circuit
- Introduction and application of microelectronic tube 6C6B
- The principle of D/A conversion using resistors
- One of three signal switches, multi-way switch CD4027 multi-way switch
- Collection of integrated operational amplifier circuit diagrams
- Basic summary of MOS tube drive circuit
- Integrating circuit-precision rectifier circuit diagram
- AN7177 power amplifier circuit diagram
- IGBT working principle diagram