Night target display circuit diagram
Source: InternetPublisher:spectrum Keywords: Circuit diagram display circuit SCR Updated: 2021/12/13
As shown in the figure, this circuit is suitable for shooting at night and turning on the street lights on the corridor.
During the day, due to sufficient light, BG3 is turned on and SCR is blocked. The oscillation circuit composed of IC , etc. has no voltage and cannot work, so the indicator light does not light up. At night, because BG3 is turned off, SCR is triggered and turned on, so the oscillation circuit composed of IC etc. starts to oscillate. IC 3 continuously outputs an ultra-low frequency square wave with a frequency of f=1/T=1.44/(W+Ra+2Rb )·C, you can see that the indicator light connected between IC 3 and ground is flashing, which is very eye-catching. Adjusting Ra·Rb to the size of C1 can change the frequency of flash.
- Measurement and analysis of automatic emergency lighting circuit
- LED Flasher circuit using 2 transistors for LED switching
- Design and production of rain control and light control timing controller based on P87LPC764
- SC3071 touch step dimming light circuit
- Gas flameout alarm circuit
- Lighting sound-activated switch circuit using thyristors Part 3
- Electronic music dimming desk lamp circuit
- Application circuit of CAT3606
- Night target display circuit diagram
- Simple sensor alarm
- Night target display circuit diagram
- Digital stopwatch display circuit
- The working principle of the microwave oven operation display circuit
- Typical operation display circuit
- Liquid crystal display circuit a using ICL7106-ICL7107 chip
- Thyristor controlled motor speed control circuit
- Program control and display circuit
- Using two pieces of LM3915 as illumination measurement display circuit
- 4-bit direct drive LCD circuit
- 4-digit incandescent lamp display circuit