Temporary power lines

When there are gatherings or celebrations in rural areas, it is often necessary to set up temporary power circuits, as shown in Figure 8-1. When connecting the temporary lamp wiring , insert one end of the two-core plastic
wire into the lamp holder, then tie a knot to increase the tension of hanging the bulb , then take off the insulation layer of the wire ends and connect them to the wiring screws of the lamp mouth respectively
, and screw them. Put on the bulbs and hang them on the branches in the yard with insulating plastic straps or on the brackets set up. The other end of the two-core stranded wire is connected to one or two
plugs and inserted into a power strip installed outdoors. When wiring , be sure to connect the phase wire of the power supply to the gold head inside the lamp socket, and the N wire
to the socket to ensure the safety of electricity. For the erection and installation of temporary switchboards, thicker two-core plastic wires should be used, with one end connected to a two-eye plug
, and the electrical plastic insulation tape should be fixed on the insulator and set up high, leading to the required place. The length of the wire can be determined according to actual needs.