Use the TV remote control to turn off the power supply of electrical appliances circuit diagram
Source: InternetPublisher:已注销 Keywords: Power supply circuit diagram TV remote control RC Updated: 2020/04/12
When the infrared receiving tube PH302 receives the signal from the remote control, it outputs a low-frequency signal through the CX20106A frequency selection amplifier. This low-level signal charges C through D and R, causing the voltage at the negative terminal of C to gradually decrease. When the potential of the negative terminal of C drops below 1/3Vcc, the discharge tube of the 555 circuit is cut off, the relay is released due to electric shock, and the power supply is cut off. The RC in the circuit can set the action sensitivity. Generally, press the remote control for 3 to 5 seconds. When the power is turned on, pressing the S1 circuit will cause the relay to self-lock.
- How to use FPGA and RS485 for industrial communication
- What is the basic principle of parametric amplifier?
- Circuit principle and production of six-tube radio
- Convenient and practical telephone automatic redial controller
- QMR1/QMR2 AM/FM 868/433.92 MHz Receiver Module
- Eight-way remote control transmitter circuit using CS901
- Cordless phone transmitter circuit
- RF2948B QPSK 2.4 GHz Spread Spectrum Transceiver
- TX500 ASK 1 GHz～100 MHz Transmitter Module
- RCV420 4～20mA Precision Current Loop Receiver
- Add amplifier before attenuation network
- Low noise ±12V power supply circuit diagram for single-ended 15V input supply
- Timing AC power supply circuit diagram that supplies power for 0-1 hour
- Stabilized current and voltage stabilized transistor amplifier power supply circuit diagram
- 3×8 LED driver circuit with overvoltage protection function
- NCP1200 driver LED circuit
- Partially resonant RCC power supply circuit diagram
- RCC mode switching power supply circuit diagram
- RC phase shift type oscillation encoder
- RC clock circuit diagram
京公网安备 11010802033920号