Overload indicator circuit diagram
Source: InternetPublisher:王达业 Keywords: indicator circuit circuit diagram comparator Updated: 2020/06/01
The two op amps are used as comparators to indicate the excess amount of the AP signal , whether positive or negative, even if the signal is asymmetric. P1 sets the reference voltage for the two operational amplifiers. This circuit uses a split power supply, which is useful for audio amplifier and op amp circuits.
Latest Control Circuits Circuits
- Build a glove-controlled robotic arm
- How to build a simple tachometer using an infrared reflectance sensor
- How to Build a Touch-Based Color-Changing Plant Using Arduino
- How to set up a cheap beam break sensor control distance scene using a reflector
- A small improvement to the temperature and water level indicator alarm
- Methods for Eliminating Noise of Brushed DC Motors
- Design and analysis of a four-bit remote control component capable of remote reset
- Simple three-phase motor phase loss protection circuit
- Password type motorcycle anti-theft device
- Large range laser burglar alarm
Popular Circuits
- Egg heating control circuit
- Multi-pole leakage protector circuit a
- Photoelectric output control circuit
- Bedside touch light detection control circuit
- Galanz rice cooker control circuit
- Microwave heating component control circuit schematic diagram
- Sign indicator circuit
- 555 bus stop indicator circuit diagram
- Telephone off-hook indicator circuit diagram
- LED fuse/indicator circuit diagram
京公网安备 11010802033920号