DC welding machine no-load automatic power-off circuit
Source: InternetPublisher:风向双子座 Keywords: Automatic power off DC welding machine AC contactor Updated: 2021/03/11
Circuit working principle: This device consists of signal power supply, transistor amplification and control circuit
. The capacitors C and C3 in the line are connected in parallel with the main contact of the AC contactor JC and in series with
the primary coil of the rectifier transformer ZB. When the switch K is closed, the normally closed
contact J of the time relay is energized and closed, and the AC contactor JC is energized and closed, making the welding machine temporarily charged. After the time
relay SJ passes with a delay of about 10 s, its normally closed contact is disconnected, the contactor JC coil
loses power, and the welding machine is in a power-off state.
- DIY a practical audio-visual doorbell
- Interpretation of CAN bus driving recorder system circuit
- Smart Farm Design Solution Based on LoRa
- Ray detection circuit
- Vehicle electronic fuel gauge circuit
- Gantry milling machine spindle control circuit
- 220V AC mains directly drives small relay circuit_3
- Wired centralized control circuit that directly starts the water pump motor
- Box type electronic mousetrap circuit
- HTS fire alarm
- Yarn dyeing machine automatic control circuit b
- Single-phase silicon rectifier DC welding machine no-load automatic stop circuit
- AC contactor low voltage starting circuit 2
- Motor multiple interlocking reversible circuit
- Two motor delay control circuits
- AC contactor DC operating circuit that does not occupy auxiliary contacts
- Fast constant current automatic power-off nickel-cadmium battery charging circuit
- Emergency wiring of AC contactor lacking auxiliary contacts B
- AC contactor low voltage starting
- Recorder automatic power off circuit
京公网安备 11010802033920号