Additional power circuit design for USB devices
Source: InternetPublisher:刘德华河北分华 Keywords: USB power circuit circuit design Updated: 2021/10/01
Most of the USB devices used today sometimes cause lack of power issues. How do you know the maximum current that can be drawn from a single USB connector is limited to 500mA . If your device requires more current, then it must include an additional USB port, which may not be available. This problem can be solved with an additional tool that uses an external unstable power supply and converts it to 5 volts.
There are two different methods you can use. There are two different methods you can use. The first, and maybe the simplest - use a simple linear regulator, but this causes other problems - wasted consumption power, but you can go the other way and use a pulse transformer, which is much more economical.
Note: The basis of the converter is a PWM controller based on the LM 2575-5 integrated circuit with an output of 5 Volts up to 1A. Enable/disable the converter using 5-pin on/off, controlled transistor VT 1.
- How about the boost converter TPS61299?
- A very convenient small power supply circuit to share
- Basic connection circuit of signal and power supply composed of ISOll3
- Switching power supply circuit composition and function introduction of each part
- How to use SBR to improve power conversion efficiency
- Electric bicycle battery charger circuit
- Constant current charger using light emitting diode as voltage regulator
- Reconstruction of the tube pre-stage by using low voltage difference power supply
- Practical constant current charger-----Constant current charger
- MAX1811 Lithium Battery Charger Production
- STMicroelectronics USB Type-C port protection IC technology
- Dual adjustable power circuit
- Solar power circuit
- Power circuit of LBO-522 dual trace oscilloscope
- Warm current power supply circuit b
- Based on TNY264P5 Volt/1.5A switching power supply circuit diagram
- Antenna amplifier synchronous power supply circuit
- Common power circuits and applications 01
- Inverter power circuit made with BJ50A
- DC-DC conversion power supply circuit