Where should the node characteristics of BlueNRG-Mesh be configured?

littleshrimp

Where should the node characteristics of BlueNRG-Mesh be configured? [Copy link]

 Today, when I was running the BlueNRG-Mesh firmware on STEVAL-IDB007V1, I measured the current. When it was not connected to the mobile phone, the current was about 10mA, and after the connection, the current was about 35mA. So I want to configure the node to have low power consumption characteristics, but I don't know where I should modify the code?

littleshrimp

BlueNRG-Mesh Bluetooth Mesh code, including IOS and Android source code STSW-BNRG-Mesh.rar (21.93 MB, downloads: 496)

2018-8-24 15:56 上传

点击文件名下载附件

nmg

Official post You can change the feature in the mesh_cfg.h file as following: If you want to config the node as LP node , you should only enable the Low_Power_Feature.

littleshrimp

nmg posted on 2018-9-12 10:07 I will post a thread on behalf of the official You can change the feature in the mesh_cfg.h file as following: If yo ...

The newly downloaded software package has this configuration file, but the previously downloaded one does not

littleshrimp

nmg posted on 2018-9-12 10:07 I will post a thread on behalf of the official You can change the feature in the mesh_cfg.h file as following: If yo ...

I downloaded the new version and tested it, and found a new problem https://en.eeworld.com/bbs/thread-926486-1-1.html