The plug behind the fascia gun cannot be plugged in.

吾妻思萌

The plug behind the fascia gun cannot be plugged in. [Copy link]

The Type-C charging port can't charge the battery, and then I press it hard and it shows charging. I think it should be the wire inside that is weak. I also want to change to direct power supply, that is, direct connection

qwqwqw2088

Just press it to display the charging status.

Take it apart, check it out, maybe the wire ends are poorly soldered, or the contact is bad.

nmg

I feel that one of the bad things about the Type-C interface is that it tends to get loose after being used for a long time.

dcexpert

Take it apart and see

dcexpert

nmg posted on 2024-2-12 13:06 I feel that one of the bad things about the type-c interface is that it seems to be easy to loosen after being used for a long time

Type-c is good, it can be plugged in both directions

tagetage

The quality of the interface, take it apart and have a look. The plug-in and unplug life of the Type-C female socket should be more than 5000 times.

秦天qintian0303

I have encountered a broken microUSB port before.

吾妻思萌

It can be displayed as charging by pressing a button.,,, I took it apart. It seems that the wire ends are poorly soldered and the contact is poor.,,

It seems to be poorly soldered after taking it apart. I can't find my father's multimeter. I will look for it tomorrow.

吾妻思萌

I feel that one of the bad things about the Type-C interface is that it tends to get loose after a long time of use.

It depends on luck. My phone has been working fine for five years, but my colleague's phone's tail plug broke after a year and a half.

吾妻思萌

It's a problem with the quality of the interface. Take it apart and have a look. The plug-in and unplug life of the Type-C female socket should be more than 5,000 times.

I think it's the place where the interface and the PCB are welded.

chunyang

Since it is disassembled, you can check the solder joints to see if it is a cold solder joint. However, the possibility of a cold solder joint is small, and the possibility of poor contact is the greatest. If the poor contact phenomenon changes after changing to a different plug, then it can be determined that it is a contact problem. Of course, you can change to other interfaces as long as there is space for installation. This can only be determined by observation.