supremeOne

SPIRIT1-Low Data Rate Transceiver-433 MHz-Daughter Board

STEVAL-IKR002V3D

Overview

The STEVAL-IKR002V3D product evaluation board is based on the SPIRIT1, a very low-power RF transceiver intended for RF wireless applications in the sub 1 GHz frequency band.

Main features

SPIRIT1 low power sub GHz transceiver in a standalone RF module tuned for 433 MHz
Modulation schemes: 2-FSK, GFSK, MSK, GMSK, OOK, and ASK
Suitable for wireless M-BUS applications
Programmable air data rate: from 1 to 500 kbps
Very low power consumption: 9.2mA RX and 19.5 mA TX at +11 dBm
Excellent receiver sensitivity (down to -120 dBm)

Low duty cycle RX/TX operation mode
Automatic acknowledgment, retransmission, and timeout protocol engine
AES 128-bit encryption co-processor
SPI interface for microcontroller
RoHS compliant

Design Files

Related Devices

Devices	Class	introduce	Datasheet
SPIRIT1		Low data rate, low power sub-1GHZ transceiver	Download

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2024-11-15 01:33:37

Output problem of triode common emitter amplifier circuit
VCC is equal to 5V, and the input Vi is a small sinusoidal signal (for example, the signal is 0~1V). How to adjust this circuit (if one transistor is not enough in the circuit, you can add another one
How to migrate custom logic from FPGA/CPLD to C2000 microcontroller
[i=s]This post was last edited by Aguilera on 2020-10-11 20:49[/i]Configurable Logic Blocks (CLBs) reduce overall system cost and increase functionality by integrating external logic into C2000 microc
There are some problems with this flyback power supply circuit
In this flyback power supply, the X pin is used for current limiting, and the V pin is used for overvoltage detection. When nothing is set, there is no voltage output at the output end of C16 when the
Serial LCD1602 using STM32-CUBE has pitfalls
[i=s]This post was last edited by Gen_X on 2021-9-25 11:22[/i]I have never learned C and started directly with STM32-CUBE. I felt good all the way. Many experts and seniors have left messages saying t
Classic experimental case of power amplifier (1) piezoelectric ceramic drive!
Humidifier, buzzer, lighter...it turns out that their principles are here → Classic experimental cases of power amplifiers (1) Piezoelectric ceramic drive!Experiment name : Piezoelectric ceramic drivi
Application of siwave in single board PI design
In circuit design, we usually only care about the quality of the signal. Due to the limitations of simulation analysis software, SI simulation research is often limited to signal lines, and the power

Datasheet More

Circuits More