Training

Location:Training / Maker Show / Cool Tech / The cheapest Tesla electric car in history, Model 3, is launched, with an official price of US$35,000 / The cheapest Tesla electric car in history, Model 3, is launched, with an official price of US$35,000

Chapter 1：The cheapest Tesla electric car in history, Model 3, is launched, with an official price of US$35,000

Duration：2 minutes and 31 seconds
Date：2016/04/07

Uploader：抛砖引玉

Introduction

keywords： Tesla Electric Vehicles Tesla Model 3

At the Tesla Model 3 launch conference, the official price was US$35,000, which is much more affordable than the Model S. It is said that it was very popular as soon as it was launched, and bookings were very popular.

You Might Like

Recommended Posts

When the input signals of SN74ABT541 are different, the output is disturbed: As shown in the figure below, only A1, A2, and A3 are input. A1 inputs a PWM signal with a duty cycle of 0.2, A2 and A3 input high level, Y1 outputs normal, Y2 and Y3 outputs seem to be affected by Y1; syn222 Analog electronics

Interview Questions: 1 What are setup and hold time? Setup time and hold time. Setup time refers to the time that the data signal needs to remain unchanged before the clock edge. Hold time refers to the time that the data; ruopu PCB Design

How to improve the throughput and uptime of automatic test equipment? Chat with VICOR engineers!: Increasing demand for more efficient factory testing capabilitiesSemiconductor manufacturers are placing greater demands on automatic test equipment (ATE) companies to quickly and reliably design test; eric_wang Power technology

Is the sensitive event table following the always in the combinational logic triggered by a high level or when the level is flipped?: As the title says, in the combinational logic, is the sensitive event table after always triggered by a high level or when the level is flipped? I think both statements are acceptable. I want to know; 平漂流 Programming Basics

Have you found the difference between F28027 and F28027F?: I bought the Launchxl-F28027 board at a low price on Xianyu. It had been idle for a few months because I was using C2000 for wireless. Recently, I wanted to use FOC technology. I looked up information; watershade Microcontroller MCU

Problems using MPLAB XIDE: In MPLAB X IDE, can't a switch statement use a variable after a case? switch(Displacement[5]) { case Displacement[0]: Run_Section = 0; // break in acceleration section; Like above, the error is as fol; asdmaill Microchip MCU

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号