Training

Location:Training / Tools/EDA / Digital VLSI Design (RTL to GDS) / 9a- Routing

You can log in to your eeworld account to continue watching：
9a- Routing
Login

Duration：3 minutes and 9 seconds
Date：2024/05/04

Uploader：抛砖引玉

Introduction

keywords： VLSI

Bar-Ilan University 83-612: Digital VLSI Design

In this course, I cover the basics of Chip Implementation, from designing the logic (RTL) to providing a layout ready for fabrication (GDS).

Lecture slides can be found on the EnICS Labs web site at:
https://enicslabs.com/academic-courses/dvd-english/

You Might Like

Recommended Posts

Have you considered these trade-offs in PCB design?: [i=s] This post was last edited by ohahaha on 2018-3-26 13:55 [/i] [align=left][size=4]When designing a more complex board, you must make some design trade-offs. Because of these trade-offs, there are; ohahaha PCB Design

Looks like something went wrong.: At 8:30 in the morning, I logged into the forum and an error code appeared. I opened it several times and it was like this. After a while, there was no prompt code and it became a blank page. After a; ienglgge Talking

Which is faster, floating point operation or Q format operation of DSP28335?: Now using 28335 to do FFT involves a lot of floating point operations. I know that 28335 is a floating point processor and can perform floating point operations, and of course it can also use Q format; blues_more Microcontroller MCU

Video: The second part of the Contiki basic demonstration rpl-border-router, ping6 demonstration: [media=x,500,375]http://v.youku.com/v_show/id_XMTM5MjQ4Nzc2MA==.html?from=y1.7-2[/media] Youku view address; CC2538cb contiki basic routines, continuously updating videos: [url]http://v.youku.com/v_sh; dan158185 RF/Wirelessly

About CAN interrupt of 8962: I would like to ask you. After my program enters the CAN interrupt, I use CANIntStatus (CAN0_BASE, CANI_INT_STS_CAUSE) to read, but why does it always return "0"? I have read a lot of documents, and d; ZHANGXUEJIE Microcontroller MCU

TM4C123G cannot simulate TI routine timers. . .: [url] I am a beginner in M4 and want to create a new program by imitating the source program. I found that after setting various paths and predefined symbols, the compilation can pass, but the functio; nemo1991 Microcontroller MCU

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号