I was doing an experiment today. Originally, my driver board could drive 3.8V 650ma current.
After a long time, the voltage of a 1W LED (3.3v350ma) is turned on.
There is not much change 3.8 +- 0.1V;
How to burn the exe program compiled by EVC to the ARM board, the board is 2410, which prawn can tell me the general steps? Can it be burned through the USB port? How to use JTAG?
[i=s]This post was last edited by paulhyde on 2014-9-15 09:38[/i] [url=https://en.eeworld.com/bbs/post.php?action=newthread&fid=57&extra=page%3D20#attachment]Audio amplifier switching regulated power
I am using a LaunchPad28027. When I run the PWM routine provided by TI, it says that I need to use a scope serial port software oscilloscope, but there is no waveform. Please give me some advice if yo