Training

Location:Training / Embedded Development / Project actual production: intelligent access control system / Card reader uploads data to computer via wifi - driver implementation (Part 1)

You can log in to your eeworld account to continue watching：
Card reader uploads data to computer via wifi - driver implementation (Part 1)
Login

Chapter 1：Intelligent access control system project introduction - hardware system and course introduction
Chapter 2：Design of intelligent access control system - system-level design and functional decomposition (Part 1)
Chapter 3：Design of intelligent access control system - system-level design and functional decomposition (Part 2)
Chapter 4：Introduction to RFID principles and modules - card reader and key card analysis (Part 1)
Chapter 5：Introduction to RFID principles and modules - card reader and key card analysis (Part 2)
Chapter 6：Rc522 card reading module driver - microcontroller project establishment and peripheral device initialization (Part 1)
Chapter 7：Rc522 card reading module driver - microcontroller project establishment and peripheral device initialization (Part 2)
Chapter 8：Rc522 card reading module driver - driver transplantation (Part 1)
Chapter 9：Rc522 card reading module driver - driver transplantation (Part 2)
Chapter 10：RC522 card reading module driver - driver debugging and card reading function verification (Part 1)
Chapter 11：Rc522 card reading module driver - driver debugging and card reading function verification (Part 2)
Chapter 12：Rc522 card reading module driver - card writing function development and verification (Part 1)
Chapter 13：Rc522 card reading module driver - development and verification of card writing function (Part 2)
Chapter 14：Rc522 card reading module driver - card writing function development and verification (Part 2)
Chapter 15：Store key information to eeprom
Chapter 16：Access control system host computer software development-interface design
Chapter 17：Access control system host computer software development-serial communication
Chapter 18：Access control system host computer software development - wifi communication with card reader
Chapter 19：Access control system host computer software development - data storage (Part 1)
Chapter 20：Access control system host computer software development - data storage (Part 2)
Chapter 21：Access control system host computer software development-release of new access control cards
Chapter 22：Card reader uploads data to computer via wifi - communication protocol design
Chapter 23：Card reader uploads data to computer via wifi - driver implementation (Part 1)
Chapter 24：Card reader uploads data to computer via wifi - driver implementation (Part 2)
Chapter 25：Simulating indoor residents going out
Chapter 26：Function integration and course summary

Duration：15 minutes and 14 seconds
Date：2022/04/24

Uploader：桂花蒸

Introduction

keywords： Internet of Things Smart access control

Introduction to Internet of Things Development + Practical Production: Intelligent Access Control System

You Might Like

Recommended Posts

Where do you buy development boards?: TI official website is too slow; 飞天有梦 Microcontroller MCU

[ESP32 Learning] ESP32 Lobo version firmware: In addition to the official firmware of MIcroPython, ESP32 also has some third-party firmware. Because the official progress on ESP32 is relatively slow, some enthusiasts have developed new functions; dcexpert MicroPython Open Source section

Commemorating the dead Raspberry Pi: Today, for some unknown reason, my Raspberry Pi B+ burned out. The chip can boil eggs. Tragic! I was planning to study hard, but it came to an abrupt end.; chenzhufly Embedded System

【sensorTile Review】01. Unboxing and Comparison: This time, the sensorTile was almost lost, but fortunately the express delivery center had good service and found it. Before receiving the express delivery, I had already had a preliminary impression,; johnrey MEMS sensors

Some thoughts on job hopping: Yesterday I posted a post about my first job. Haha, I saw some comments from friends. Is it too frequent to change three companies in three years? Will it affect future job hunting? Will I be at a los; yujiyuan1984 Talking about work

PCB board: When doing single-sided board wiring, can it be done on the top or bottom layer? Can text be added on the same layer as the line? Or must it be on different layers?; hql724914 PCB Design

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号