Training

Location:Training / Embedded Development / Internet of Things vehicle application practice / Overall design of embedded software for project implementation

You can log in to your eeworld account to continue watching：
Overall design of embedded software for project implementation
Login

Chapter 1：Course introduction and tutorial
Chapter 2：Project introduction and display
Chapter 3：Project process introduction and analysis (1)
Chapter 4：Project process introduction and analysis (2)
Chapter 5：Analysis of key technical points of the project: Introduction to Bluetooth
Chapter 6：Introduction to Bluetooth module HC-05, analysis of key technologies of the project
Chapter 7：Project key technology analysis: sensor and storage technology
Chapter 8：Analysis of key and difficult points in the project: Introduction to Bluetooth protocol
Chapter 9：Analysis of project key points and difficulties: Bluetooth module HC-05 small demo (1)
Chapter 10：Analysis of project key points and difficulties: Bluetooth module HC-05 small demo (2)
Chapter 11：Analysis of project key points and difficulties: Bluetooth module HC-05 small demo (3)
Chapter 12：Analysis of project key points and difficulties: Bluetooth module HC-05 small demo (4)
Chapter 13：Analysis of key and difficult points in the project: motion sensor data calculation, alarm strategy, storage strategy
Chapter 14：Introduction to hardware design for project implementation
Chapter 15：Overall design of embedded software for project implementation
Chapter 16：Design of various modules of embedded software for project implementation
Chapter 17：Software and hardware joint debugging and project summary of project implementation

Duration：15 minutes and 56 seconds
Date：2022/03/20

Uploader：JFET

Introduction

keywords： Internet of Things Internet of Vehicles

IoT vehicle application practical video tutorial

You Might Like

Recommended Posts

Fujitsu FRAM Experience Submission: Fuji's FRAM (Ferroelectric Memory) has the same non-volatility as E[/font][/color]2[color=#000][font=Arial]PROM. When the system is powered off, it can automatically save data and can be used in indus; lshjiang Integrated technical exchanges

Quick-Jack is now available, let's share our experience and answer your questions: [i=s]This post was last edited by kejoy on 2014-6-7 22:01[/i] :pleased:[font=Tahoma,]I received the board this afternoon. It was very fast. It arrived at 3pm today after it was sent yesterday. First o; kejoy Talking

How to use internal flash storage in 430G series: I am using 430G series chips to make a small device. I want to use the internal flash to store some simple coefficients. Can anyone tell me about this application?; jishuaihu Microcontroller MCU

Enhanced performance 100-bit gate driver improves efficiency of advanced communications power modules: Abstract Communications applications use power modules based on half-bridge, full-bridge, or synchronous buck power topologies. These topologies use high-performance half-bridge drivers to achieve hig; alan000345 TI Technology Forum

C51 pin pull-up problem: sbit BEEP = P1^3; BEEP=1; //Buzzer for(beep_delay=10;beep_delay>0;beep_delay--); BEEP=0; The buzzer buzzes and then turns off, but the BEEP pin remains low. Why?; evildoor Embedded System

PCI Express Bus Problems: I am working on some hardware related to PCIE bus interface recently. I have only read a little about PCIE bus and I don't know much about the driver. I want to ask, how to initiate a DMA request to t; maxipeiz Embedded System

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号