Training

Location:Training / Maker Show / Raspberry Pi / Build the Internet of Things with Raspberry Pi and wireless modules / Use Raspberry Pi and wireless modules to build the Internet of Things (3) NodeMCU open source Internet of Things platform

You can log in to your eeworld account to continue watching：
Use Raspberry Pi and wireless modules to build the Internet of Things (3) NodeMCU open source Internet of Things platform
Login

Chapter 1：Using Raspberry Pi and wireless modules to build the Internet of Things (1) System display
Chapter 2：Use Raspberry Pi and wireless modules to build the Internet of Things (2) Wiring
Chapter 3：Use Raspberry Pi and wireless modules to build the Internet of Things (3) NodeMCU open source Internet of Things platform

Duration：8 minutes and 47 seconds
Date：2015/07/08

Uploader：chenyy

Introduction

keywords： Internet of Things raspberry pie Wireless Module

1. Use Raspberry Pi 2, 8266 Wi-Fi module, simple receiver (used to connect to Wi-Fi AP) and transmitter to build the Internet of Things. Raspberry Pi 2 as server.

2. Connect the ESP cable on the breadboard, configure different firmware for the ESP, install NodeMCU on the ESP, and install NodeJS on the Raspberry Pi.

You Might Like

Recommended Posts

Conflict between watchdog and sleep mode of STM32 chip: Dear experts: I am going to make a handheld device recently and need to use the STOP mode of stm32F103. But at the same time, I have enabled the independent watchdog. Whenever I enter the STOP mode, t; 孤帆 stm32/stm8

MCD2/ICD2 Beginner's Guide: [i=s]This post was last edited by paulhyde on 2014-9-15 09:37[/i]; gina Electronics Design Contest

Talk about the upper and lower tubes of the buck circuit_DC-DC BUCK bootstrap circuit: What is a bootstrap capacitor? The DC-DC BUCK chip has a pin called BOOT, some called BST, as shown below:How does the bootstrap capacitor work? The following is the block diagram of the DCDCBUCK chip; Jacktang Analogue and Mixed Signal

I feel that the RAM of msp430 is not enough: Less than 2K RAM, if there is more data (due to the requirement of speed, it cannot be placed in Flash), excluding the local variables called by the subroutine, I don't know how much can be used. The; news986 Microcontroller MCU

Can intelligent robots recognize themselves?: Today's robots can only be considered intelligent, they will work automatically according to instructions. But can they achieve autonomous work like humans, with plans and purposes, and know why they; ginny

ETA Intelligent Power Relay E-1048-8D for Automotive Electronics: On March 6, ETA launched the E-1048-8D (E-1048 Dice), an intelligent power relay for the transportation industry, which can remotely disconnect electronic loads and match the 4-pin automotive electron; frozenviolet Automotive Electronics

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号